Back
 ENG  Vol.3 No.12 , December 2011
The Bending of Rectangular Deep Beams with Fixed at Both Ends under Uniform Load
Abstract: The Maroochy River, which is located on east coast of Australia, provides a variety of uses and values to the community. Changes in structure, function and management of the river will influence the value that the community derives from it. Therefore, critical to the river’s continued management is the development of policy relevant tools based on the community’s value of the river. This paper focuses on estimating the financial value the local residents derive from living close to the river through investigation of changes in residential property values due to attributes of the Maroochy River. It is a complex analysis since there are several confounding geographical and property variables. Given a large and complete dataset of 28,000 properties for the Maroochy region, Artificial Neural Networks (ANN) was applied to estimate the economic value of the properties. This ANN was then able to simulate scenarios for property values with respect to changes in environmental features. It showed the Maroochy River contributed AU$900,000,000 to the unimproved capital value of the whole region, a value that could not be estimated previously, and much higher than anticipated. Calculating potential annual payments to the Shire Council through land tax analysis from these property values, provides the council with means to justify expenditure to maintain a standard of water quality and ecosystem health.
Cite this paper: nullY. Chen, B. Fu, G. Li, J. Wu, M. Bai and X. Chen, "The Bending of Rectangular Deep Beams with Fixed at Both Ends under Uniform Load," Engineering, Vol. 3 No. 12, 2011, pp. 1182-1191. doi: 10.4236/eng.2011.312147.
References

[1]   G. Q. Liu and K. Sun, “The Research of Concrete Deep Beams,” Technology Information, Vol. 3, 2008, pp. 88-89.

[2]   X. Xu, “Consistent Variation from Levinson Theory to High Times Warp Beam Theory,” Engineering Mechanics, Vol. 25, No. 2, 2008, pp. 56-61.

[3]   S. P. Timoshenko and J. M. Gere, “Strength of Materials,” Vannostrand Company, New York, 1972, pp. 45-63.

[4]   R. D. Mindlin, “Influence of Rotary Inertia and Shear on Flexural Motions of Isotropic, Elastic Plates,” Journal of Applied Mechanics, Vol. 18, No. 1, 1951, pp. 31-38.

[5]   G. R. Cowper, “The Shear Coefficient in Timoshenko’s Beam Theory,” Journal of Applied Mechanics, Vol. 33, No. 2, 1966, pp. 335-340. doi:10.1115/1.3625046

 
 
Top