WSN  Vol.3 No.9 , September 2011
Wireless Power Generation Strategy Using EAP Actuated Energy Harvester for Marine Information Acquisition
ABSTRACT
The energy of a radio wave is reduced through the dispersion, the refraction and the absorption because the medium transferring the vibration of a radio wave is the seawater. In the end the reduced energy of a radio wave causes the reduced transmitting length for communication, the long postponed communication and the frequent error. The subsea communication for the marine environment monitoring which must overcome the weak points of the RF wave and the most practical method for the marine sensor network realization is to use the acoustic wave method, but the energy consumption rate of the acoustic wave communication method is about 100 times greater than the one of the RF wave method. So, the power supply of the sensor node in the marine sensor network system is the most important interest field. In this study, the sample which consists of an acrylic elastomer(VHB4905 film from 3M), conductible carbon grease(from MG chemical) and electric wire for the basic study of an energy harvesting strategy and technique using EAP actuator was fabricated, and the conductible carbon grease was used for an electrode. The characteristics of the fabricated sample were analyzed through the experiment. We also mixed carbon grease with aluminum powder for conductibility improvement, and the effect of the mixed electrode was confirmed through the conductivity measurement.

Cite this paper
nullS. Yun, E. Jeong, H. Jeong and K. Lee, "Wireless Power Generation Strategy Using EAP Actuated Energy Harvester for Marine Information Acquisition," Wireless Sensor Network, Vol. 3 No. 9, 2011, pp. 313-317. doi: 10.4236/wsn.2011.39033.
References
[1]   Han, S. H. and Cho, B. K., “A Study on the Development of Marine Detector Using Nano-technology”, Journal of the Korean Society of Marine Environment & Safty, Vol. 14, No. 1, pp. 39-43, 2008.

[2]   Choi, H. Y. and Park, S. H., “a Group Base Sub Sink Under-water Wireless Sensor Network Routing”, the 2006 Annual spring conference of the Korean Society for Simulation, pp. 149-156, 2006.

[3]   Yu, Y. H., Gang, Y. S. and Lee, W. B., “Development of a Floating Buoy for Monitoring Ocean Environment”, Journal of the Korean Society of Marine Engineering, Vol. 33, No. 5, pp. 705-712, 2009.

[4]   Park, S. J., Park, S. H., Kim, S, G. and Kim, C. H., “Marine sensor network technique”, Journal of the Korean Institute of Information Scientists and Engineers, Vol. 28, No. 7, pp. 79-88, 2010.

[5]   Kim, D. W. et al., “The Study of Improvement Performance Techniques for Self Sustaining Sensor Node System Using Acquire Vibration Energy”, the 2009 Annual fall conference of the Korean Institute of Electrical Engineers, pp. 97-98, 2009.

[6]   Park, K. J. et al., “Self-powered Wireless Sensor using MEMS/MOSFET Hybrid Switch”, the 2010 Annual Summer conference of the Korean Institute of Electrical Engineers, pp. 1179-1180, 2010.

[7]   Kang, S. M. et al., “Power Management Circuit for Solar Cell Powered Wireless Sensor Nodes”, the 2009 Annual Summer conference of the Korean Institute of Electrical Engineers, pp. 1925-1926, 2009.

[8]   Chang, H. K., Kim, D. J. and Park, J. Y., “Use of Piezoelectric Effect in Portable Loadless Wind-Power Source for Ubiquitous Sensor Networks”, Journal of the Korean Society of Mechanical Engineers B, Vol. 34, No. 6, pp. 623-628, 2010.

[9]   Perlin, R. et al., “High-Speed Electrically Actuated Elastomers With Strain Greater than 100%”, Journal of Science, No. 287, pp. 836-839, 2000.

[10]   Kofod., G., “Dielectric elastomer actuators”, the Techniacl University of Denmark, Lyngby, pp. 2-20, 2001.

[11]   http://www.mgchemicals.com, 2011.

[12]   http://products3.3m.com, 2011

 
 
Top