OALibJ  Vol.1 No.6 , September 2014
Fire Resistant K-Based Metakaolin Geopolymer for Passive Fire Protection of Concrete Tunnel Linings
Abstract: A fire resistant metakaolin geopolymer is developed and its performance under thermal loading is examined in this paper. The geopolymer was prepared by mixing metakaolin, doped with solid SiO2, with a highly alkaline potassium hydroxide aqueous phase in order to create a paste that was subsequently cured at 70℃ for a certain period of time. The addition of solid SiO2 was important in order the geopolymer developed to be fire resistant for temperatures up to 1350℃. The mechanical, physical and thermal properties of the metakaolin geopolymer were measured and compared with available commercial fire resistant materials. The behavior of the metakaolin geopolymer upon exposure on fire was studied following the EFNARC guidelines for testing of passive fire protection for concrete tunnels linings. The geopolymer was subjected to the most severe fire scenario, the Rijks Water Staat (RWS) temperature-time curve. During the test, the temperature in the geopolymer/concrete interface remained under 220℃, which is 160℃ lower than the RWS test requirement, proving the ability of material to work successfully as an efficient thermal barrier. After the test the surface of the geopolymer had exfoliated and cracked, without losing its structural integrity. Thus, the concrete slab protected by the geopolymer did not appear any form of spalling or degradation of its compressive strength.
Cite this paper: Sakkas, K. , Kapelari, S. , Panias, D. , Nomikos, P. and Sofianos, A. (2014) Fire Resistant K-Based Metakaolin Geopolymer for Passive Fire Protection of Concrete Tunnel Linings. Open Access Library Journal, 1, 1-9. doi: 10.4236/oalib.1100806.

[1]   Davidson, M.T., Harik I.E. and Davis D.B. (2013) Fire Impact and Passive Fire Protection of Infrastructure: State of the Art. Journal of Performance of Constructed Facilities, 27, 135-143.

[2]   N.C.M.A, National Codes and Standards Council of the Concrete and Masonry Industries, 1994. Assessing the Condition and Repair Alternatives of Fire Exposed Concrete and Masonry Members. Fire Protection Planning Report.14.

[3]   Davidovits, J. (1999) Chemistry of Geopolymeric Systems, Terminology. Proceedings of the 2nd International Conference on Geopolymer'99, Saint Qunentin, 9-39.

[4]   Murri, A.N., Rickard, W.D.A., Bignozzi, M.C. and Van Riessen, A. (2013) High Temperature Behaviour of Ambient Cured Alkali-Activated Materials Based on Ladle Slag. Cement and Concrete Research, 43, 51-61.

[5]   Rickard, W.D.A., Vickers, L. and Van Riessen, A. (2013) Performance of Fibre Reinforced, Low Density Metakaolin Geopolymers under Simulated Fire Conditions. Applied Clay Science, 73, 71-77.

[6]   Cheng, T.W. and Chiu, J.P. (2003) Fire-Resistant Geopolymer Produced by Granulated Blast Furnace Slag. Minerals Engineering, 16, 205-210.

[7]   EFNARC, European Federation of National Associations Representing Producers and Applicators of Specialist Building Products for Concrete, 2009. Specification and Guidelines for Testing of Passive Fire Protection for Concrete Tunnels Lining.

[8]   ISRM (1978) Suggested Methods for Determining Tensile Strength of Rock Materials Part 2: Suggested Method for determining indirect tensile strength by the Brazil Test. International Journal of Rock Mechanics and Mining Sciences, 15, 99-103.

[9]   Centre d’etudes des tunnels CETU, 2010. Sprayable mortars for fire protection.

[10]   (1995) Slag Atlas. 2nd Edition, Verlag Stahleisen GmbH, Düsseldorf.