Back
 EPE  Vol.7 No.11 , October 2015
Overvoltage Condition Assessment of a Microgrid Due to Faults Occurring in the Islanded Mode of Operation
Abstract: This paper presents the results of the simulations and their respective analyses corresponding to the power frequency overvoltages resulting from various fault types occurring inside a microgrid. During the islanded mode of operation, the analysed microgrid can be simultaneously fed by a diesel generator, a 1 MW wind power turbine, a small solar system and a 1 MW hydroelectric scheme. The operating voltage of the microgrid is 2.4 kV. During a fault in the system, the overvoltages normally occur in two remarkable instants. The first one occurs at the beginning of the fault itself. The second one occurs at the instant when the fault is cleared. The major concern here is the overvoltage during the fault period. Due to the travelling wave effect along cables and overhead lines composing the microgrid system, these overvoltages can be amplified, thus jeopardizing the insulation level of the microgrid transmission system and related equipment. Much of the work available now is dedicated to overvoltages present in high-voltage systems leaving a gap for the study and behaviour on low voltage microgrid systems. The overvoltage stress is characterized by the maximum low-frequency, short-duration (crest value) of the overvoltage. Both cables and overhead lines that constitute the microgrid transmission system are characterized by their R-L-C parameters. The simulations of the microgrid system are conducted using the ATP program. According to the international ANSI and IEEE standards, the minimum BIL (Basic Impulse Insulation Level) and BSL (Basic Impulse Switching Level) for the 2.4 kV voltage level are 20 kV and 10 kV, respectively; thus, care should be taken so that the healthy phases upon which commonly appear such overvoltages are not exceeded in their insulation level.
Cite this paper: Vasquez-Arnez, R. , Ramos, D. and Huayllas, T. (2015) Overvoltage Condition Assessment of a Microgrid Due to Faults Occurring in the Islanded Mode of Operation. Energy and Power Engineering, 7, 525-534. doi: 10.4236/epe.2015.711049.
References

[1]   Shuiming, C. and Hongqiao, Y. (2010) A Review on Overvoltages in Microgrid. 2010 Asia-Pacific Power and Energy Engineering Conference (APPEEC), Chengdu, 28-31 March 2010, 1-4.

[2]   Yang, W., Peng, Z., Li, W.Y., Xiao, W.D. and Adollahi, A. (2012) Online Overvoltage Prevention Control of Photovoltaic Generators in Microgrids. IEEE Transactions on Smart Grid, 3, 2071-2078.
http://dx.doi.org/10.1109/TSG.2012.2222679

[3]   Pokharel, S.P., Brahma, S.M. and Ranade, S.J. (2012) Modeling and Simulation of Three Phase Inverter for Fault Study of Microgrids. North American Power Symposium (NAPS), Champaign, 9-11 September 2012, 1-6.
http://dx.doi.org/10.1109/naps.2012.6336325

[4]   Franklin, A., Yan, R.F. and Saha, T.K. (2013) Investigation of a Micro-Grid Operation: A Case Study of Heron Island Network (Australia). 2013 Australasian Universities Power Engineering Conference (AUPEC). Hobart, 29 September-23 October 2013, 1-6.
http://dx.doi.org/10.1109/AUPEC.2013.6725422

[5]   Hongqiao, Y., Shuiming C. and Yang, P.C. (2010) Study on Transferred Lightning Overvoltage in Microgrid. 2010 Asia-Pacific Symposium on Electromagnetic Compatibility (APEMC), Beijing, 12-16 April 2010, 1550-1553.
http://dx.doi.org/10.1109/apemc.2010.5475606

[6]   Vasquez-Arnez, R.L., Ramos, D.S. and Del Carpio-Huayllas, T.E. (2014) Microgrid Dynamic Response during the Pre-Planned and Forced Islanding Processes Involving DFIG and Synchronous Generators. International Journal of Electrical Power & Energy Systems, 62, 175-182.

[7]   PSCAD/EMTDC Program, Manitoba HVDC Research Center, v.4.3.1.0 (x4), 2010. https://hvdc.ca/pscad/

[8]   Alternative Transients Program (ATPDraw). v 5.5, 1998-2007.
http://www.atpdraw.net/

[9]   Sarma, M.S. (1994) Electric Machines: Steady-State Theory and Dynamic Performance. 2nd Edition, PWS Pub. Co., Boston.

[10]   Hase, Y. (2007) Handbook of Power System Engineering. John Wiley & Sons Ltd, England, 451-452.
http://dx.doi.org/10.1002/9780470033678

[11]   (2010) IEEE Std C62.82.1?-2010, IEEE Standard for Insulation Coordination-Definitions, Principles, and Rules.

[12]   Broussard, D.G. (2013) Understanding Short Circuit Motor Contribution. Vector, 45.
http://www.ee.co.za/wp-content/uploads/legacy/Vector%202013/vector_june2013_ge.pdf

 
 
Top