OJCE  Vol.5 No.2 , June 2015
Compressive and Flexural Behaviour of Unstressed Concrete Substructure in Cassava Effluent Contaminated Soils
Abstract: Concrete research is gradually shifting from the conventional strength-based approach to durability-centred in the past decade. Durability is the measure of the robustness of constructed facilities against deterioration tendencies. The rate of deterioration is affected by the loading condition, and more importantly the physical and chemical nature of the host environments. This paper reports the experimental investigation of unstressed concrete substructure in the natural (uncontaminated) and cassava’s hydrocyanide effluent-polluted soils on the compressive and flexural strengths of buried concrete specimens for a maximum of 84 days. The compressive strengths of the cubes were tested every 7 days until the 84th day, while the beams were only subjected to third-point loading flexural tests at age 84 days. The compressive strength of concrete specimens in the two soil environments increased, though the trend was lower in the polluted soil. The strength reduced by 2.50% to 9.47% between the 7th and 28th days, but steadily between the 28th and 84th days with strength loss of 9.95% (COV = 2.64%). The load-deflection curves were quadratic for the beams in the two geo-environments. The beams in cyanide-polluted soil lost 34.5% of its flexural stiffness, while its loss of load-carrying capacities at the first crack and ultimate failure was 15.8% and 20% respectively. Higher degree of deterioration is certain for loaded concrete substructures in similar conditions. Hence, prior knowledge of soil chemistry is crucial to determining suitable concrete grade and nominal cover for durable substructural elements.
Cite this paper: Adewuyi, A. , Olaniyi, O. , Olafusi, O. and Fawumi, A. (2015) Compressive and Flexural Behaviour of Unstressed Concrete Substructure in Cassava Effluent Contaminated Soils. Open Journal of Civil Engineering, 5, 239-248. doi: 10.4236/ojce.2015.52024.

[1]   Adewuyi, A.P., Wu, Z.S. and Serker, N.H.M.K. (2009) Assessment of Vibration Based Damage Identification Methods Using Displacement and Distributed Strain Measurements. International Journal of Structural Health Monitoring, 8, 443-461.

[2]   Adewuyi, A.P., Wu, Z.S. and Raheem, A.A. (2010) Adaptation of Vibration-Based SHM for Condition Assessment and Damage Detection of Civil Infrastructure Systems. LAUTECH Journal of Engineering & Technology, 6, 1-11.

[3]   Adewuyi, A.P. and Wu, Z.S. (2011) Vibration-Based Damage Localization in Flexural Structures Using Normalized Modal Macrostrain Techniques from Limited Measurements. Computer-Aided Civil and Infrastructure Engineering, 26, 154-172.

[4]   Cohen M.D. and Bentur A. (1988) Durability of Portland Cement-Silica Fume Pastes in Magnesium Sulfate and Sodium Sulfate Solutions. ACI Materials Journal, 85, 148-157.

[5]   Mehta P.K. (1983) Mechanism of Sulfate Attack on Portland Cement Concrete: Another Look. Cement & Concrete Research, 13, 401-406.

[6]   Kosmatka, S.H., Kerkhoff, B. and Panarese, W.C. (2003) Design and Control of Concrete Mixtures. 14th Edition. Portland Cement Association, Skokie.

[7]   Schneider, U. and Piasta, W.G. (1991) The Behaviour of Concrete under Na2SO4 Solution Attack and Sustained Compression or Bending. Magazine for Concrete Research, 43, 281-289.

[8]   American Concrete Institute (2008) Building Code Requirements for Structural Concrete, ACI 318-08. Farmington Hills.

[9]   American Concrete Institute (1999) Guide to Durable Concrete. ACI 201.2R-99. Farmington Hills.

[10]   Canadian Standard Association (1994) Concrete: Constituents and Construction Practices, A23.1-94. Rexdale, Ontario.

[11]   DePuy, G.W. (1994) Chemical Resistance of Concrete. In: Klieger, P. and Lamond, J.., Eds., Significance of Tests and Properties of Concrete and Concrete-Making Materials, STP 169C, ASTM, Philadelphia, 263-281.

[12]   Marchand, J., Samson, E., Maltais, Y. and Beaudoin, J.J. (2002) Theoretical Analysis of the Effect of Weak Sodium Sulfate Solutions on the Durability of Concrete. Cement & Concrete Composites, 24, 317-329.

[13]   Hong, K. and Hooton, R.D. (1999) Effects of Cyclic Chloride Exposure on Penetration of Concrete Cover. Cement & Concrete Research, 29, 1379-1386.

[14]   Bentur, A., Goldman, A. and Ben-Bassat, M. (1995) High Performance Concretes in Concentrated Magnesium Sulfates, Magnesium Chlorides and Sodium Sulfates Solution. Proceedings of the International Conference on Concrete under Severe Conditions: Environment and Loading, Sapporo, 2-4 August 1995, 1237-1246.

[15]   Filho, L.C.P.S. and Agopyan, V. (1995) Effect of Silica Fume on Concretes against Sulfate Attack. Proceedings of the International Conference on Concrete under Severe Conditions: Environment and Loading, Sapporo, 2-4 August 1995, 1227-1236.

[16]   Zuquan, J., Wei, S., Yunsheng, Z., Jinyang, J. and Jianzhong, L. (2007) Interaction between Sulfate and Chloride Solution Attack of Concretes with and without Fly Ash. Cement and Concrete Research, 37, 1223-1232.

[17]   Bader, M.A. (2003) Performance of Concrete in Coastal Environment. Cement & Concrete Composites, 25, 539-548.

[18]   Skalny, J., Marchand, J. and Odler, I. (2001) Sulfate Attack on Concrete. E & FN, London.

[19]   Haynes, H., O’Neill, R. and Mehta, P.K. (1996) Concrete Deterioration from Physical Attack by Salt. Concrete International, 18, 63-68.

[20]   Pradhan, B. and Bhattacharjee, B. (2009) Performance Evaluation of Rebar in Chloride Contaminated Concrete by Corrosion Rate. Construction and Building Materials, 23, 2346-2356.

[21]   Mehta, P.K. (1990) Concrete in the Marine Environment (Modern Concrete Technology). CRC Press, Boca Raton.

[22]   Lea, F.M. (2003) The Chemistry of Cement and Concrete. Chemical Publishing Co., New York, 89-114.

[23]   Lawrence, C.D. (1990) Sulphate Attack on Concrete. Magazine of Concrete Research, 42, 249-264.

[24]   Osakwe, S.A. (2012) Effect of Cassava Processing Mill Effluent on Physical and Chemical Properties of Soils in Abraka and Environs, Delta State, Nigeria. Chemistry and Materials Research, 2, 27-39.

[25]   Ohochuku, N.S. (2005) Odorless Fermentation of Tubers of Cassava (Manchot esculenta Graritz). Journal of Health and Environmental Research, 6, 62-69.

[26]   Aluko, O.O., Sridhar, M.K.C. and Oluwande, P.A. (2003) Characterization of Leachates from a Municipal Solid Waste Land Fill Site in Ibadan, Nigeria. Journal of Environmental Health Research, 2, 32-37.

[27]   Amusan, A.A., Ige, D.V. and Olawale, R. (2005) Characteristics of Soils and Crops Uptake of Metals in Municipal Waste Dumpsites in Nigeria. Journal of Human Ecology, 17, 167-171.

[28]   Osemwota, O.I. (2010) Effect of Abattoir Effluent on the Physical and Chemical Properties of Soils. Environmental Monitoring Assessment, 167, 399-404.

[29]   Okafor, N. and Uzuegbu, J.O. (1987) Studies on the Contribution of Micro-Organism on the Organo-Leptic Properties of Garri—A Fermented Food Derived from Cassava (Manilot esculenta Crantz). Journal of Food and Agriculture, 2, 99-105.

[30]   Ige, O.O. and Olaifa, A.O. (2013) Groundwater Pollution Assessment around Waste Disposal Sites in Part of Lagos State, Nigeria. ARPN Journal of Earth Sciences, 2, 54-61.

[31]   Olowofela, J.A. and Akinyemi, O.D. (2001) A Numerical Model for the Migration and Fate of Contaminants in Groundwater. Nigerian Journal of Science, 35, 87-93.

[32]   Kola-Olusanya, A. (2012) Impact of Municipal Solid Wastes on Underground Water Sources in Nigeria. European Scientific Journal, 8, 1-19.

[33]   Ademoroti, C.M.A. (1996) Environmental Chemistry and Toxicology. Foludex Press Ltd., Ibadan.

[34]   World Health Organization (2004) Maximum Allowable Concentration of Selected Water Quality Variables. WHO, Geneva.

[35]   Latha, P., Thangavel, P., Velayutham, K. and Arulmozhiselvan, K. (2012) Effect of Distillery Industrial Wastes Application on Nutrient Dynamics in Soil. International Journal of Advanced Life Sciences, 4, 16-23.

[36]   BS 1881 (2013) Testing Concrete. Methods for Mixing and Sampling Fresh Concrete in the Laboratory, Part 125. British Standards Institution, London.