Back
 ENG  Vol.7 No.5 , May 2015
Theoretical Research on R245fa Condensation Heat Transfer inside a Horizontal Tube
Abstract: Numerical simulation on R245fa condensation inside an inner diameter of 8 mm horizontal tube is researched in this paper. The effect of variation in velocity, condensation temperature and superheat of inlet steam and variation in cooling water temperature on heat transfer coefficient are investigated as a parametric study. Condensation process of steam has been successfully modeled by applying a user defined function (UDF) added to the commercial computational fluid dynamics (CFD) package. By analyzing the corresponding condensate contours and the curves of local heat transfer coefficient, the relationships between condensation heat transfer coefficient and various parameters of R245fa inside horizontal tube are obtained. It shows that the heat transfer coefficient increases by the increase in velocity, condensation temperature and superheat of inlet steam and the decrease in cooling water temperature. The errors between the heat transfer coefficient of simulation result and model of Wang and Shah are within ±30%. The parametric study will provide the basis for designing efficient heat exchangers of R245fa.
Cite this paper: Liu, S. , Huo, Y. , Liu, Z. , Li, L. and Ning, J. (2015) Theoretical Research on R245fa Condensation Heat Transfer inside a Horizontal Tube. Engineering, 7, 261-271. doi: 10.4236/eng.2015.75023.
References

[1]   Wang, X.D., Zhao, L. and Wang, J.L. (2000) Experimental Investigation on the Low-Temperature Solar Rankine Cycle System Using R245fa. Energy Conversion and Management, 52, 946-952.
http://dx.doi.org/10.1016/j.enconman.2010.08.022

[2]   Angelino, G. and Invernizzi, C. (2003) Experimental Investigation on the Thermal Stability of Some New Zero ODP Refrigerants. International Journal of Refrigeration, 26, 51-58.
http://dx.doi.org/10.1016/S0140-7007(02)00023-3

[3]   Saleh, B., Koglbauer, G., Wendland, M. and Fischer, J. (2007) Working Fluids for Low-Temperature Organic Rankine Cycles. Energy, 32, 1210-1221.
http://dx.doi.org/10.1016/j.energy.2006.07.001

[4]   Wang, X.D., Zhao, L., Wang, J.L., Zhang, W.Z., Zhao, X.Z. and Wu, W. (2010) Performance Evaluation of a Low- Temperature Solar Rankine Cycle System Utilizing R245fa. Solar Energy, 84, 353-364.
http://dx.doi.org/10.1016/j.solener.2009.11.004

[5]   Eames, I.W., Ablwaifa, A.E. and Petrenko, V. (2007) Results of an Experimental Study of an Advanced Jet-Pump Refrigerator Operating with R245fa. Applied Thermal Engineering, 27, 2833-2840.
http://dx.doi.org/10.1016/j.applthermaleng.2006.12.009

[6]   Zou, Y. and Hrnjak, P.S. (2014) Effects of Fluid Properties on Two-Phase Flow and Refrigerant Distribution in the Vertical Header of a Reversible Microchannel Heat Exchanger—Comparing R245fa, R134a, R410A, and R32. Applied Thermal Engineering, 70, 966-976.
http://dx.doi.org/10.1016/j.applthermaleng.2014.06.021

[7]   Vakili-Farahani, F., Agostini, B. and Thome, J.R. (2013) Experimental Study on Flow Boiling Heat Transfer of Multiport Tubes with R245fa and R1234ze(E). International Journal of Refrigeration, 36, 335-352.
http://dx.doi.org/10.1016/j.ijrefrig.2012.12.007

[8]   Tibiriçá, C.B. and Ribatski, G. (2010) Flow Boiling Heat Transfer of R134a and R245fa in a 2.3 mm Tube. International Journal of Heat and Mass Transfer, 53, 2459-2468.
http://dx.doi.org/10.1016/j.ijheatmasstransfer.2010.01.038

[9]   Ong, C.L. and Thome, J.R. (2009) Flow Boiling Heat Transfer of R134a, R236fa and R245fa in a Horizontal 1.030 mm Circular Channel. Experimental Thermal and Fluid Science, 33, 651-663.
http://dx.doi.org/10.1016/j.expthermflusci.2009.01.002

[10]   Pike-Wilson, E.A. and Karayiannis, T.G. (2014) Flow Boiling of R245fa in 1.1 mm Diameter Stainless Steel, Brass and Copper Tubes. Experimental Thermal and Fluid Science, 59, 166-183.
http://dx.doi.org/10.1016/j.expthermflusci.2014.02.024

[11]   Agostini, B., Thome, J.R., Fabbri, M., Michel, B., Calmi, D. and Kloter, U. (2008) High Heat Flux Flow Boiling in Silicon Multi-Microchannels—Part II: Heat Transfer Characteristics of Refrigerant R245fa. International Journal of Heat and Mass Transfer, 51, 5415-5425.
http://dx.doi.org/10.1016/j.ijheatmasstransfer.2008.03.007

[12]   Rabha, S.S. and Buwa, V.V. (2009) Volume-of-Fluid (VOF) Simulations of Rise of Single/Multiple Bubbles in Sheared Liquids. Chemical Engineering Science, 65, 527-537.
http://dx.doi.org/10.1016/j.ces.2009.06.061

[13]   Yang, Z., Peng, X.F. and Ye, P. (2008) Numerical and Experimental Investigation of Two Phase Flow during Boiling in a Coiled Tube. International Journal of Heat and Mass Transfer, 51, 1003-1016.
http://dx.doi.org/10.1016/j.ijheatmasstransfer.2007.05.025

[14]   Huang, M., Yang, Z., Duan, Y.Y. and Lee, D.J. (2011) Bubble Growth for Boiling Bubbly Flow for R141b in a Serpentine Tube. Journal of the Taiwan Institute of Chemical Engineers, 42, 727-734.
http://dx.doi.org/10.1016/j.jtice.2011.02.007

[15]   Chen, S.H., Yang, Z., Duan, Y.Y., Chen, Y. and Wu, D. (2014) Simulation of Condensation Flow in a Rectangular Microchannel. Chemical Engineering and Processing, 76, 60-69.
http://dx.doi.org/10.1016/j.cep.2013.12.004

[16]   Da Riva, E. and Del Col, D. (2012) Numerical Simulation of Laminar Liquid Film Condensation in a Horizontal Circular Minichannel. Journal of Heat Transfer, 134, Article ID: 051019.
http://dx.doi.org/10.1115/1.4005710

[17]   Wang, L., Li, Y.Z., Li, C. and Zhao, Z.X. (2013) CFD Investigation of Thermal and Pressurization Performance in LH2 Tank during Discharge. Cryogenics, 57, 63-73.
http://dx.doi.org/10.1016/j.cryogenics.2013.05.005

[18]   Wang, W.W.W., Radcliff, T.D. and Christensen, R.N. (2002) A Condensation Heat Transfer Correlation for Millimeter-Scale Tubing with Flow Regime Transition. Experimental Thermal and Fluid Science, 26, 473-485.
http://dx.doi.org/10.1016/S0894-1777(02)00162-0

[19]   Shah, M.M. (2010) Heat Transfer during Condensation inside Small Channels: Applicability of General Correlation for Macrochannels. Proceedings of the 14th International Heat Transfer Conference, Washington DC, 8-13 August 2010, 298-303.

 
 
Top