MSCE  Vol.3 No.5 , May 2015
Performance of Galvanized Steel Reinforcement in Concrete in Sea and Dead Sea Water
Abstract: Steel reinforcements of 8 mm diameter and 24 cm length were cut from steel and after pickling treatment of all specimens. Steel reinforcements then were galvanized by hot dipping method. The measured coating thickness by thickness gage meter of zinc coat was in the range 8 - 11 μm. Bare steel samples were also used for comparison reasons. Each steel bar was inserted in a middle of a plastic tube with 4.5 cm diameter into which concrete was cast. After proper curing, specimens were immersed into 3.5% NaCl and Dead Sea water separately. Electrochemical impedance spectroscopy measurements were performed at different time intervals. Results showed that galvanized steel was corrosion resistant in sea water, and Dead Sea water over the test period.
Cite this paper: Masadeh, S. (2015) Performance of Galvanized Steel Reinforcement in Concrete in Sea and Dead Sea Water. Journal of Materials Science and Chemical Engineering, 3, 46-53. doi: 10.4236/msce.2015.35006.

[1]   Cornet, I. and Bresler, B. (1981) Galvanized Reinforcement for Concrete—II. International Lead Zinc Research Organization, New York, 1.

[2]   Andrade, C., Macias, A., Molina, A. and Gonzales, J.A. (1985) Technical Symposia - Corrosion 85. Boston, 25-29 March 1985, NACE, Houston, Paper N 270.

[3]   Andrade, C. and Macias, A. (1988) In: Wilson, A.D., Nicholson, J.W. and Prosser, H.J., Eds., Surface Coating-2, Elsevier Applied Science, London, 137.

[4]   Sergi, G., Short, N.R. and Page, C.L. (1985) Corrosion of Galvanized and Galvannealed Steel in Solutions of pH 9.0 to 14.0. Corrosion, 41, 418.

[5]   Sergi, G., Short, N.R. and Page, C.L. (1985) Corrosion, 41, 418.

[6]   Virmani, Y.P. and Clemena, G.G. (1998) Corrosion Protection: Concrete Bridges. Report No. FHWA-RD-98-088, Federal Highway Administration, Washington DC.

[7]   Bentur, A. Diamond, S. and Berke, N.S. (1997) Steel Corrosion in Concrete. E and FN Spon, New York, 201 pp.

[8]   Chess, P.M. (1998) Cathodic Protection of Steel in Concrete. E and FN Spon, New York, 187 pp.

[9]   Jones, D.A. (1996) Principles and Prevention of Corrosion. 2nd Edition, Prentice Hall, Upper Saddle River, New Jersey, 572 pp.

[10]   Polder, R.B. (1998) Cathodic Protection of Reinforced Concrete Structures in the Netherlands—Experience and Developments. HERON, 43, 3-14.

[11]   Clear, K.C. (1981) Time-to-Corrosion of Reinforcing Steel in Concrete Slabs: Vol. 4. Galvanized Reinforcing Steel. Report No. FHWA-RD-82-028, Federal Highway Administration, Washington DC.

[12]   Locke, C.E. and Siman, A. (1980) Electrochemistry of Reinforcing Steel in Salt-Contaminated Concrete. In: Corrosion of Reinforcing Steel in Concrete, STP 713, American Society of Testing and Materials, Philadelphia, 3-26.

[13]   Manning, D.G. (1996) Corrosion Performance of Epoxy-Coated Reinforcing Steel: North American Experience. Construction and Building Materials, 10, 349-365.

[14]   Polder, R. (1994) Electrochemical Chloride Removal of Reinforced Concrete Prisms Containing Chloride from Sea Water Exposure. UK Corrosion and EUROCORR’94, 239-248.

[15]   Clifton, J.R., Beehgly, H.F. and Mathey, R.G. (1974) Nonmetallic Coatings for Concrete Reinforcing Bars. Report No. FHWA-RD-74-18, Federal Highway Administration, Washington DC, 87 p.

[16]   Clear, K.C. and Virmani, Y.P. (1983) Corrosion of Non-Specification Epoxy-Coated Rebars in Salty Concrete. Paper No. 114, CORROSION/83, Anaheim.

[17]   Clear, K.C., Hartt, W.H., McIntyre, J. and Lee, S.K. (1995) Performance of Epoxy-Coated Reinforcing Steel in Highway Bridges. NCHRP Report No. 370, Transportation Research Board, Washington DC.

[18]   McCrum, L. and Arnold, C.J. (1993) Evaluation of Simulated Bridge Deck Slabs Using Uncoated, Galvanized, and Epoxy Coated Reinforcing Steel. Research Report No. R-1320, Michigan Department of Transportation, Lansing.

[19]   Virmani, Y.P. and Clemena, G.G. (1998) Corrosion Protection-Concrete Bridges. Report No. FHWA-RD-98-088, Federal Highway Administration, Washington DC.

[20]   Lemoine, L., Wenger, F. and Galland, J. (1990) Study of the Corrosion of Concrete Reinforcement by Electrochemical Impedance Measurement. In: Berke, N.S., Chaker, V. and Whiting, D., Eds., Corrosion Rates of Steel in Concrete, ASTM STP 1065, American Society for Testing and Materials, Philadelphia, 118-133.

[21]   Liu, J. and Vipulanandan, C. (1999) Testing Epoxy Coatings for Dry and Wet Concrete Wastewater. Journal of Protective Coatings and Linings, SSPC, 16, 26-37.

[22]   Electrochemical Impedance Spectroscopy Apparatus User Manual.

[23]   Ageta, W. (1998) Field Performance of Epoxy-Coated Reinforcing Steel in Virginia Bridge Decks. Ph.D. Thesis, Civil Engineering Department, Blacksburg.

[24]   Kendig, M.W., Mansfeld, F. and Tsai, S. (1983) Determination of the Long Term Corrosion Behavior of Coated Steel with AC Impedance Measurements. Corrosion Science, 23, 317-329.

[25]   Mansfeld, F. and Kendig, M.W. (1984) Evaluation of Protective Coatings with Impedance Measurements. Proceedings of the 9th International Congress on Metallic Corrosion, National Research Council of Canada, Ottawa, 3.74-78.

[26]   Callow, L.M. and Scantlebury, J.D. (1981) Electrochemical Impedance on Coated Metal Electrodes, Part I. Polarization Effects. Journal of the Oil and Color Chemists’ Association, 64, 83-86.

[27]   Taylor, S.R., Cahen Jr., G.L. and Stoner, G.E. (1989) Ion-Beam-Assisted Deposition of Thin Carbonaceous Films. III. Barrier Properties. Journal of the Electrochemical Society, 136, 929-935.

[28]   Leidheiser, H. and Funke, W. (1987) Water Disbondment and Wet Adhesion of Organic Coatings on Metals: A Review and Interpretation. Journal of the Oil and Color Chemists’ Association, 70, 121-132.

[29]   De Wit, J.H.W. (1995) Inorganic and Organic Coatings. In: Marcus, P. and Oudar, J., Eds., Corrosion Mechanisms in Theory and Practice, Marcel Dekker, Inc., New York.