Back
 EPE  Vol.6 No.12 , October 2014
Electrical Parameters Investigation and Zero Flow Rate Effect of Nitrogen Atmospheric Nonthermal Plasma Jet
Abstract: The construction and operation of atmospheric nonthermal plasma jet, ANPJ, are presented in this work as well as the experimental investigations of its electrical parameters, the configuration of plasma jet column and its temperature. The device is energized by a low-cost Neon power supply of (10 kV, 30 mA, and 20 kHz) and the discharge takes place by using N2 gas with different flow rates from 3 to 25 L/min and input voltage of 6 kV. Diagnostic techniques such as voltage divider, Lissajous figure, image processing and thermometer are used. The electrical characteristics of discharge at different flow rates of N2 gas such as discharge voltage, current, mean power, power efficiency, and mean energy have been studied. The experimental results show that the maximum plasma jet length of 14 mm is detected at flow rate of 12 L/min. The results of plasma jet (heavy particles) temperature along the jet length show that jet plasma has approximately a room temperature at the jet column end. The results of zero flow rate effect on the ANPJ operation show damage in the Teflon insulator and a corrosion in the Aluminum electrodes.
Cite this paper: Allam, T. , Ward, S. , El-sayed, H. , Saied, E. , Soliman, H. and Ahmed, K. (2014) Electrical Parameters Investigation and Zero Flow Rate Effect of Nitrogen Atmospheric Nonthermal Plasma Jet. Energy and Power Engineering, 6, 437-448. doi: 10.4236/epe.2014.612036.
References

[1]   Mohamed, A.-A.H., Kolb, J.F. and Schoenbach, K.H. (2010) Low Temperature, Atmospheric Pressure, Direct Current Microplasma Jet Operated in Air, Nitrogen and Oxygen. The European Physical Journal D, 60, 517-522.
http://dx.doi.org/10.1140/epjd/e2010-00220-7

[2]   Choi, Y.-H., Kim, J.-H., Paek, K.-H., Ju, W.-T. and Hwang, Y.S. (2005) Characteristics of Atmospheric Pressure N2 Cold Plasma Torch Using 60-Hz AC Power and Its Application to Polymer Surface Modification. Surface & Coatings Technology, 193, 319-324.
http://dx.doi.org/10.1016/j.surfcoat.2004.08.145

[3]   Tyata, R.B., Subedi, D.P., Shrestha, A. and Baral, D. (2012) Development of Atmospheric Pressure Plasma Jet in Air. Kathmandu University Journal of Science, Engineering and Technology, 8, 15-22.

[4]   Benedikt, J., Focke, K., Gil, A.Y. and Keudell, A.V. (2006) Atmospheric Pressure Microplasma Jet as a Depositing Tool. Applied Physics Letters, 89, Article ID: 251504.
http://dx.doi.org/10.1063/1.2423233

[5]   Shin, D.H., Bang, C.U., Kim, J.H., Hong, Y.C., Uhm, H.S., Park, D.K. and Kim, K.H. (2006) Treatment of Metal Surface by Atmospheric Microwave Plasma Jet. IEEE Transactions on Plasma Science, 34, 4.
http://dx.doi.org/10.1109/TPS.2006.882534

[6]   Akamatsu, H. and Ichikawa, K. (2011) Characteristics of Atmospheric Pressure Plasma Jet Generated by Compact and Inexpensive High Voltage Modulator. Surface & Coatings Technology, 206, 920-924.
http://dx.doi.org/10.1016/j.surfcoat.2011.04.050

[7]   Xu, G.-M., Ma, Y. and Zhang, G.-J. (2008) DBD Plasma Jet in Atmospheric Pressure Argon. IEEE Transactions on Plasma Science, 36, 4.
http://dx.doi.org/10.1109/TPS.2007.908905

[8]   Nehra, V., Kumar, A. and Dwivedi, H. (2008) Atmospheric Non-Thermal Plasma Sources. International Journal of Engineering, 2, 53-68.

[9]   Ahmed, K.M., Allam, T.M., El-sayed, H.A., Soliman, H., Warad, S. and Saied, E. (2014) Design, Construction and Characterization of AC Atmospheric Pressure Air Non-Thermal Plasma Jet. Journal of Fusion Energy, 33, 627-633
http://dx.doi.org/10.1007/s10894-014-9720-7

[10]   Russell, G.J. and Mann, K. (1990) Introductory Alternating Current Circuit Theory. Universities Press (India) Limited, Hyperabad.

[11]   Xiong, Q., Lu, X.P., Ostrikov, K., Xian, Y., Zou, C., Xiong, Z. and Pan, Y. (2010) Pulsed dc- and Sine-Wave-Excited Cold Atmospheric Plasma Plumes: A Comparative Analysis. Physics of Plasmas, 17, Article ID: 043506.
http://dx.doi.org/10.1063/1.3381132

[12]   Cai, Y., Zhang, L., Wang, J., Ran, D. and Wang, J. (2010) Measuring DBD Main Discharge Parameters Using Q-V Lissajous Figures. Power and Energy Engineering Conference (APPEEC), Asia-Pacific, Chengdu, China.

[13]   Lingareddy, E., Biju, V.M. and Subrahmanyam, C. (2011) Non-Thermal Plasma Assisted Direct Decomposition of H2S into H2 and S. International Journal of Chemical and Environmental Engineering, 2, 87-90.

[14]   Laroussi, M. (2009) Low-Temperature Plasmas for Medicine. IEEE Transactions on Plasma Science, 37, 6.
http://dx.doi.org/10.1109/TPS.2009.2017267

[15]   Wang, Q., Doll, F., Donnelly, V.M., Economou1, D.J., Sadeghi, N. and Franz, G.F. (2007) Experimental and Theoretical Study of the Effect of Gas Flow on Gas Temperature in an Atmospheric Pressure Microplasma. Journal of Physics D: Applied Physics, 40, 4202-4211.
http://dx.doi.org/10.1088/0022-3727/40/14/015

 
 
Top