OJG  Vol.4 No.5 , May 2014
A Compilation of the Geo-Mechanical Properties of Rocks in Southern Ontario and the Neighbouring Regions
Abstract: The available measurements of the geo-mechanical properties of rocks in Southern Ontario and the neighbouring regions (New York, Ohio, Michigan, Indiana, Illinois, Wisconsin, and Minnesota) are summarized and presented. These measurements were compiled from available published data in the relevant literature and also from data that were collected from major underground projects in these regions. The compiled data are presented in three categories: measured in-situ stresses in different rock formations; calculated strength, stiffness and deformation including time-dependent deformation properties; and the measured dynamic properties of intact rock specimens from different rock formations in Southern Ontario and the neighbouring regions. The data presented in this paper can be used as a resource for preliminary evaluation of the geomechanical properties of the rocks in these regions. The presented geo-mechanical properties were generally obtained from in-situ measurements and from laboratory tests that were conducted on intact rock specimens from freshly excavated rock samples. Moreover, the time-dependent deformation properties of rocks in these regions were obtained from laboratory tests that were performed on intact rock specimens submerged in water. However, the influence of drilling fluids such as bentonite slurry and synthetic polymers solution, on the geo-mechanical properties of rocks is not evident and needs to be investigated.
Cite this paper: Al-Maamori, H. , El Naggar, M. and Micic, S. (2014) A Compilation of the Geo-Mechanical Properties of Rocks in Southern Ontario and the Neighbouring Regions. Open Journal of Geology, 4, 210-227. doi: 10.4236/ojg.2014.45017.

[1]   Lo, K.Y. (1978) Regional Distribution of in Situ Horizontal Stresses in Rocks of Southern Ontario. Canadian Geotechnical Journal, 15, 371-381.

[2]   Lo, K. Y., and Yuen, C.M.K. (1981) Design of Tunnel Lining in Rock for Long Term Time Effects. Canadia Geotechnical Journal, 18, 24-39.

[3]   Lo, K.Y. (1089) Recent Advances in Design and Evaluation of Performance of Underground Structures in Rocks. Tunnelling and Underground Space Technology, 4, 171-183. (89)90050-3

[4]   Lo, K.Y., Cooke, B.H. and Dunbar, D.D. (1987) Design of Buried Structures in Squeezing Rock in Toronto, Canada. Canadian Geotechnical Journal, 24, 232-241.

[5]   Lo, K.Y. and Hori, M. (1979) Deformation and Strength Properties of Some Rocks in Southern Ontario. Canadian Geotechnical Journal, 16, 108-120.

[6]   Lo, K.Y. and Lee, Y.N. (1990) Time-Dependent Deformation Behaviour of Queenston Shales. Canadian Geotechnical Journal, 27, 461-471.

[7]   Lo, K.Y., Palmer, J. H. L. and Quigly, R.M. (1978) Time-Dependent Deformation of Shaly Rocks in Southern Ontario. Canadian Geotechnical Journal, 15, 537-547.

[8]   Lee, Y.N. and Lo, K.Y. (1993) The Swelling Mechanism of Queenston Shale. Canadian Tunnelling, 75-97.

[9]   Hefney, A., Lo, K.Y. and Huang, J.A. (1996) Modelling of Long-Term Time-Dependent Deformation and Stress Dependency of Queenston Shales. Tunnelling Association of Canada Annual Publication, 115-146.

[10]   Map of Southern Ontario and Neighbouring Regions, Google Maps.

[11]   Terzaghi, K. (1962) Measurement of Stresses in Rock. Géotechnique, 12, 105-124.

[12]   Von Schonfeldt, H. and Fairhurst, C. (1972) Field Experiments on Hydraulic Fracturing. American Institute of Mining Engineers, 253, 69-77.

[13]   Lindner, E.N. and Halpern, J.A. (1978) In-Situ Stress in North America: A Compilation. International Journal of Rock Mechanics and Mining Sciences and Geomechanics Abstracts, 15, 183-203.

[14]   Rough, R.L. and Lambert, W.G. (1971) ln-Situ Strain Orientations: A Comparison of Three Measuring Techniques. Report of Investigation, 7575, US Department of Interior, Bureau of Mines, USA.

[15]   Haimson, B.C. (1976) The Hydrofracturing Stress Measuring Technique-Method and Recent Field Results in the US. The Proceedings of the International Society of Rock Mechanics Symposium, Sydney, 23-30.

[16]   Lo, K.Y. and Hefney, A. (1993) The Evaluation of In-Situ Stresses by Hydraulic Fracturing Tests in Anisotropic Rocks with Mixed-Mode Fractures. Canadian Tunnelling, 59-73.

[17]   Haimson, B. and Fairhurst, C. (1970) In-Situ Stress Determination at Great Depth by Means of Hydraulic Fracturing. Rock Mechanics—Theory and Practice. The Proceedings of the 11th Symposium on Rock Mechanics, 16-19 June 1969, Berkeley, 559-584.

[18]   van Heerden, W.L. and Grant, F. (1967) A Comparison of Two Methods for Measuring Stress in Rock. International Journal of Rock Mechanics and Mining Sciences & Geomechanics Abstracts, 4, 367-382.

[19]   Haimson, B. and Stahl, E.J. (1969) Hydraulic Fracturing and the Extraction of Minerals through Wells. The Proceedings of the 3rd Symposium on Salt, Northern Ohio Geological Society, Cleveland, 421-432.

[20]   Lam, T., Engelder, T., Leech, R.E.J. and Jensen, M. (2011) Regional Geomechanics–Southern Ontario. Nuclear Waste Management Organization and AECOM Canada Ltd., Technical Report No. NWMO DGR-TR-2011-13.

[21]   Obert, L.A. (1962) In-situ Determination of Stress in Rock. Mining Engineering, 14, 51-58.

[22]   Buchbinder, G.G.R., Nyland, E. and Blanchard, J.E. (1965) Measurement of Stress in Bore-Holes, in Drilling for Scientific Purposes. Proceedings of the International Upper Mantle Symposium, Ottawa, 2-3 September 1965, 85-93.

[23]   Fairhurst, C. (2004) Nuclear Waste Disposal and Rock Mechanics: Contributions of the Underground Research Laboratory (URL), Pinawa, Manitoba, Canada. International Journal of Rock Mechanics and Mining Sciences, 41, 1221-1227.

[24]   Palmer, H.L. and Lo, K.Y. (1976) In Situ Measurements in Some near Surface Rock Formation—Thorold, Ontario. Canadian Geotechnical Journal, 13, 1-7.

[25]   Lo, K.Y., Yung, C.B. and Lukajic, B. (1987) A Field Method for the Determination of Rock-Mass Modulus. Canadian Geotechnical Journal, 24, 406-413.

[26]   Hefney, A. and Lo, K.Y. (1995) Interpretation of Initial Stresses from Hydraulic Fracturing Tests at AECL’s Underground Research Laboratory, Manitoba. Tunnelling Association of Canada Annual Publication, 123-134.

[27]   Hoek, E. (2001) Big Tunnels in Bad Rocks—2000 Terzaghi Lecture. American Society of Civil Engineers Journal of Geotechnical and Geoenvironmental Engineering, 127, 726-740.

[28]   Herget, G. (1973) Variation of Rock Stresses with Depth at a Canadian Iron Mine. International Journal of Rock Mechanics and Mining Sciences & Geomechanics Abstracts, 10, 37-51.

[29]   Eisbacher, G.H. and Bielenstein, H.U. (1971) Elastic Strain Recovery in Proterozonic Rocks Near Elliot Lake, Ontario. Journal of Geophysical Research, 76, 2012-2021.

[30]   Canada. Mines Branch, Coates, D.F., Grant, F. and Heerden, W.L. (1968) Stress Measurements at Elliot Lake. Canada Mines Branch Reprint Series, R. Duhamel, 603-613.

[31]   Franklin, J.A. and Hungr, O. (1978) Rock Stresses in Canada: Their Relevance to Engineering Projects. Rock Mechanics, 6, 25-46.

[32]   Lo, K.Y., Lukajic, B., Yuen, C.M.K. and Hori, M. (1982) In-Situ Stresses in a Rock Overhang at the Ontario Power Generating Station, Niagara Falls. Proceedings of the 23rd Symposium on Rock Mechanics, Berkeley, 25-27 August 1982, 343-352.

[33]   Moruzi, G.A. (1968) Application of Rock Mechanics in Mine Planning and Ground Control. Current Rock Mechanics, Chap. 3, Studies at Falconbridge. Canadian Mining Journal, 89, 12-15.

[34]   Metaltech Inspection Ltd. (1970) Rapport D’Investigation, Measure Des Constraintes En Place. Contract No. 1009-61, Commission Hydro-Electrique du Quebec.

[35]   Benson, R.P., Kierans, T.W. and Sigvaldason, O.T. (1970) In-Situ and Induced Stresses at the Churchill Falls Underground Powerhouse, Labrador. Proceedings of the 2nd Congress of the International Society for Rock Mechanics, 4, 821-832.

[36]   Hefney, A. and Lo, K.Y. (1992) The Interpretation of Horizontal and Mixed-Mode Fractures in Hydraulic Fracturing Test in Rocks. Canadian Geotechnical Journal, 29, 902-917.

[37]   Fairhurst, C. (2003) Stress Estimation in Rock: A Brief History and Review. International Journal of Rock Mechanics and Mining Sciences, 40, 957-973.

[38]   Thompson, P.M. and Chandler, N.A. (2004) In-Situ Rock Stress Determinations in Deep Boreholes at the Underground Research Laboratory. International Journal of Rock Mechanics and Mining Sciences, 41, 1305-1316.

[39]   Sbar, M.L. and Sykes, L.R. (1973) Contemporary Compressive Stress and Seismicity in Eastern North America: An Example of Intra-Plate Tectonics. Geological Society of America Bulletin, 84, 1861-1882.<1861:CCSASI>2.0.CO;2

[40]   Sellers, J.B. (1969) Strain Relief Overcoring to Measure in-Situ Stresses. Niagara Falls Project, Corps of Engineers, Buffalo District.

[41]   Hooker, V.E. and Johnson, C.F. (1977) In-Situ Stresses along the Appalachian Piedmont. Proceedings of the 4th Canadian Symposium on Rock Mechanics, Ottawa, 29-30 March 1967, 137-155.

[42]   Goldberg, Z. and Dunnicliff and Associates (1976) Report on in-Situ Stress Measurements, Genessee River Interceptor, Southwest Rochester, NewYork, File No. 1661, Firelands Sewer and Water Construction Company, New York.

[43]   Dames and Moore Consultants (1973) In-Situ Stress Measurement. Report of Investigation, North Anna Power Project.

[44]   Dames and Moore Consultants (1974) Geological Report. Report No. 4852-002-18, Limerick Generating Station.

[45]   Bonnechere, F. (1969) A Comparative Field Study of Rock Stress Determination Techniques. Missouri River Division, Report No. 68101, Corps of Engineers, Omaha.

[46]   Foundation Sciences Incorporation (1971) Bear Swamp Project-Rock Mechanics Studies. New England Power Service Company, Westborough.

[47]   Lo, K.Y. and Lukajic, B. (1984) Predicted and Measured Stresses and Displacements around the Darlington Intake Tunnel. Canadian Geotechnical Journal, 21, 147-165.