Back
 JPEE  Vol.2 No.4 , April 2014
The Study of Optimal Structure and Value of Dump Resistance in Direct-Drive Permanent Magnet Synchronous Generators
Abstract: This paper studied the direct-drive permanent magnet synchronous machine (permanent magnet synchronous generator, PMSG) Chopper optimal topology and resistance value. Compared the different Chopper circuit low voltage ride-through capability in the same grid fault conditions in simulation. This paper computes the dump resistance ceiling according to the power electronic devices and over-current capability. Obtaining the dump resistance low limit according to the temperature resistance allows, and calculating the optimal value by drop voltage in the DC-Bus during the fault. The feasibility of the proposed algorithm is verified by simulation results.
Cite this paper: Jia, J. , Zhao, J. , Liu, D. , Cheng, C. , Wang, J. and Qi, L. (2014) The Study of Optimal Structure and Value of Dump Resistance in Direct-Drive Permanent Magnet Synchronous Generators. Journal of Power and Energy Engineering, 2, 334-339. doi: 10.4236/jpee.2014.24044.
References

[1]   Hansen, A.D. and Hansen, L.H. (2007) Wind Turbine Concept Market Penetration over 10 Years (1995-2004). Wind Energy, 81-97. http://dx.doi.org/10.1002/we.210

[2]   Li, G.Q. (2007) Power System Transient Analysis. China Electric Power Press, Beijing.

[3]   Zhang, M. (2008) Studies on the Modeling and Control System of Direct-Drive Permanent Magnet Synchronous Generator Based Wind Turbine. Master Thesis, Xi’an University of Technology, Xi’an.

[4]   Zhang, X. (2008) Low Voltage Ride-Through Technologies in Wind Turbine Generation. Proceedings of the CSU- EPSA, 20, 1-8.

[5]   Akhmatov, V. (2003) Analysis of Dynamic Behavior of Electric Power Systems with Large Amount of Wind Power. Ph.D.Thesis, Rsted DTU, 1-260.

[6]   Brando, G. Coccia, A. and Rizzo, R. (2004) Control Method of a Braking Chopper to Reduce Voltage Unbalance in a 3-Level Chopper. IEEE International Conference on Industrial Technology ICIT, 2, 975-978.

[7]   Zhao, H.L., Yang, Y.X. and Wang, W.Q. (2010) Fault Ride-Through Simulation of Permanent Magnetic Synchronous Generator Connected into Power Grid. Power System and Clean Energy, 26, 15-18.

[8]   Yang, Y.X., Liu, G.Q. and Du, B.X. (2012) Low Voltage Ride Through Technology Applied to Permanent Magnet Direct-driving Wind Generator Units. Journal of Electric Power, 27, 103-106.

[9]   Xu, Q.H. and Cao, B.Z. (2012) Low Voltage Ride Through of 1.5 MW DFIG Converter under Symmetric Grid Failure. Dong Fang Turbine, 1-4.

[10]   Li, S.H. (2013) Optimal Value and Group Switching Strategy of Dump Resistance for Direct-Drive Permanent Magnet Synchronous Generators. Power System Technology, 37, 1-7.

[11]   Conroy, J. and Watson, R. (2009) Aggregate Modeling of Wind Farms Containing Full-Converter Wind Turbine Generators with Permanent Magnet Synchronous Machines: Transient Stability Studies. Renewable Power Generation, IET, 3, 39-52. http://dx.doi.org/10.1049/iet-rpg:20070091

[12]   Hansen, A.D. and Michalke, G. (2009) Multi-Pole Permanent Magnet Synchronous Generator Wind Turbines’ Grid Support Capability in Uninterrupted Operation during Grid Faults. Renewable Power Generation, IET, 3, 333-348. http://dx.doi.org/10.1049/iet-rpg.2008.0055

[13]   Akhmatov, V. and Nielsen, H. (2003) Variable-Speed Wind Turbines with Multi-Pole Synchronous Permanent Magnet Generators. Part I: Modeling in Dynamic Simulation Tools. Winden-gineering, 27, 531-548. http://dx.doi.org/10.1260/030952403773617490

[14]   Zhao, H.L., Wang, W.Q. and Wang, H.Y. (2010) Dynamic Characteristic Simulation of Permanent Magnetic Synchronous Generator Connected into Power Grid. Power System & Automation, 32.

 
 
Top