MSA  Vol.4 No.12 , December 2013
Structural and Magnetic Properties of Mn0.50-xZn0.50CuxFe2O4
ABSTRACT

Mn0.50-xZn0.50CuxFe2O4 (where x = 0.0 - 0.3) ferrites have been synthesized by auto combustion method. X-ray diffraction patterns reveal that all compositions are of single phase cubic spinel structure. The lattice parameter decreases with the increase in Cu2+ content obeying the Vegard’s law. The bulk density, average grain size, initial permeability, Néel temperature and saturation magnetic induction of Mn0.50-xZn0.50CuxFe2O4 increased with increasing Cu2+content. It is observed that both density and initial permeability increase with increasing sintering temperature. The maximum initial permeability is found to be 1061 which is almost four times greater than that of the parent composition. The resonance frequency of all the samples shifts towards the lower frequency as the permeability increases with Cu2+ content. It is observed from B-H loops of Mn0.50-xZn0.50CuxFe2O4 that coercivity decreases and retentivity increases with Cu2+ content. Possible explanations for the observed magnetic properties with various Cu2+ contents are discussed.


Cite this paper
F. Alam, M. Khan, H. Das and A. Hossain, "Structural and Magnetic Properties of Mn0.50-xZn0.50CuxFe2O4," Materials Sciences and Applications, Vol. 4 No. 12, 2013, pp. 831-838. doi: 10.4236/msa.2013.412106.
References
[1]   K. Praveena, K. Sadhana, S. Bharadwaj and S. R. Murthy, “Developement of Nanocrystalline Mn-Zn Ferrites for High Frequency Transformer Applications,” Journal of Magnetism and Magnetic Materials, Vol. 321, 2009, pp. 2433-2437. http://dx.doi.org/10.1016/j.jmmm.2009.02.138

[2]   P. Mathur, A. Thakur and M. Singh, “Low Temperature Synthesis of Mn0.4Zn0.6In0.5Fe1.5O4 Nano Ferrite for HighFrequency Applications,” Journal of Physics and Chemistry of Solids, Vol. 69, No. 1, 2008, pp. 187-192.
http://dx.doi.org/10.1016/j.jpcs.2007.08.014

[3]   J. Kalarus, G. Kogias, D. Holz and V. T. Zaspalis, “High Permeability-High Frequency Stable MnZn Ferrites”, Journal of Magnetism and Magnetic Materials, Vol. 324, No. 18, 2012, pp. 2788-2794.
http://dx.doi.org/10.1016/j.jmmm.2012.04.011

[4]   A. Goldman, “Modern Ferrite Technology,” Van Nostrand Reinhold, New York, 1990.

[5]   Amarendra K. Singh, Abhishek K. Singh, T. C. Goel and R. G. Mendiratta, “High Performance Ni-Substituted MnZn Ferrites Processed by Soft Chemical Technique”, Journal of Magnetism and Magnetic Materials, Vol. 281, No. 2-3, 2004, pp. 276-280.
http://dx.doi.org/10.1016/j.jmmm.2004.04.115

[6]   H. Su, H. W. Zhang, X. L. Tang and X. Y. Xiang, “HighPermeability and High-Temperature NiCuZn Ferrite”, Journal of Magnetism and Magnetic Materials, Vol. 283, No. 2-3, 2004, pp. 157-163.
http://dx.doi.org/10.1016/j.jmmm.2004.05.017

[7]   M. Manjurul Haque, M. Huq and M. A. Hakim, “Influence of CuO and Sintering Temperature on the Microstructure and Magnetic Properties of Mg-Cu-Zn Ferrites,” Journal of Magnetism and Magnetic Materials, Vol. 320, No. 21, 2008, pp. 2792-2799.
http://dx.doi.org/10.1016/j.jmmm.2008.06.017

[8]   M. H. R. Khan and A. K. M. Akther Hossain, “Reentrant Spin Glass Behavior and Large Initial Permeability of Co0.5-xMnxZn0.5Fe2O4,” Journal of Magnetism and Magnetic Materials, Vol. 324, No. 4, 2012, pp. 550-558.
http://dx.doi.org/10.1016/j.jmmm.2011.08.039

[9]   A. K. M. Akther Hossain and M. L. Rahman, “Enhancement of Microstructure and Initial Permeability Due to Cu Substitution in Ni0.50-xCuxZn0.50Fe2O4 Ferrites,” Journal of Magnetism and Magnetic Materials, Vol. 323, No. 15, 2011, pp. 1954-1962.
http://dx.doi.org/10.1016/j.jmmm.2011.02.031

[10]   J. B. Nelson and D. P. Riley, “An Experimental Investigation of Extrapolation Methods in the Dimensions of Accurate Unit-Cell,” Cambridge, 1944.

[11]   L. Vegard, “The Constitution of Mixed Crystals and the Space Occupied by Atoms,” Zeitscchrift fur Physik, Vol. 5, No. 17, 1921, pp. 17-26.

[12]   R. D. Shanon and C. T. Prewitt, “Effective Ionic Radii in Oxides and Fluorides,” Acta Crystallographica, Vol. 25, No. B, 1969, pp. 925-946.

[13]   V. G. Patil, Sagar E. Shirsath, S. D. More, S. J. Shukla and K. M. Jadhav, “Effect of Zinc Substitution on Structural and Elastic Properties of Cobalt Ferrites,” Journal of Alloys and Compounds, Vol. 488, No. 1, 2009, pp. 199203. http://dx.doi.org/10.1016/j.jallcom.2009.08.078

[14]   D. Ravinder, L. Balachander and Y. C. Venudhar, “Electrical Conductivity in Manganese Substituted Lithium Ferrites,” Materials Letters, Vol. 49, No. 5, 2001, pp. 267-271.
http://dx.doi.org/10.1016/S0167-577X(00)00381-5

[15]   D. R. Lide, “CRC Handbook of Chemistry and Physics,” 76th Edition, CRC Press, Boca Raton, 1995.

[16]   S. E. Shirsath, B. G. Toksha, R. H. Kadam, S. M. Patage, D. R. Mane, G. S. Jangam and A. Ghashemi, “Doping Effect of Mn2+on the Magnetic Behavior in Ni-Zn Ferrite Nanoparticles Prepared by Sol-Gel Auto-Combustion,” Journal of Physics and Chemistry of Solids, Vol. 71, No. 12, 2010, pp. 1669-1675.
http://dx.doi.org/10.1016/j.jpcs.2010.08.016

[17]   M. Manjurul Haque, M. Huq and M. A. Hakim, “Densification, Magnetic and Dielectric Behavior of Cu-Substituted Mg-Zn Ferrites,” Materials Chemistry and Physics, Vol. 112, No. 2, 2008, pp. 580-586.
http://dx.doi.org/10.1016/j.matchemphys.2008.05.097

[18]   S. R. Murthy, “A Study of Ultrasonic Velocity and Attenuation on Polycrystalline Ni-Zn Ferrites,” Bulletin of Material Science, Vol. 24, No. 6, 2001, pp. 611-616.
http://dx.doi.org/10.1007/BF02704009

[19]   K. O. Low and F. R. Sale, “Electromagnetic Properties of Gel-Derived NiCuZn Ferrites,” Journal of Magnetism and Magnetic Materials, Vol. 246, No. 1-2, 2002, pp. 30-35. http://dx.doi.org/10.1016/S0304-8853(01)01390-7

[20]   M. I. Mendelson, “Average Grain Size in Polycrystalline Ceramics,” Journal of American Ceramic Society, Vol. 52, No. 8, 1969, pp. 443-446.
http://dx.doi.org/10.1111/j.1151-2916.1969.tb11975.x

[21]   J. L. Snoek, “Dispersion and Absorption in Magnetic Ferrites at Frequencies above One Mc/s,” Physica, Vol. 14, No. 4, 1948, pp. 207-217.
http://dx.doi.org/10.1016/0031-8914(48)90038-X

[22]   A. Globus, P. Duplex and M. Guyot, “Determination of Initial Magnetization Curve from Crystallites Size and Effective Anisotropy Field,” IEEE Transactions Magazine, Vol. 7, No. 3, 1971, pp. 617-622.
http://dx.doi.org/10.1109/TMAG.1971.1067200

[23]   T. Nakamura, “Low Temperature Sintering of Ni-Zn-Cu Ferrite and Its Permeability Spectra,” Journal of Magnetism and Magnetic Materials, Vol. 168, 1997, pp. 285-291. http://dx.doi.org/10.1016/S0304-8853(96)00709-3

[24]   J. Smit and H. P. J. Wijn, “Ferrites,” Philips’ Technical Library, 1959.

[25]   J. Hu and M. Yan, “Preparation of High-Permeability NiCuZn Ferrite,” Journal of Zhejiang University Science B, Vol. 6, No. 6, 2005, pp. 580-583.

[26]   T. Tsutaoka, M. Ueshima, T. Tokunaga, T. Nakamura and K. Hatakeyama, “Frequency Dispersion and Temperature Variation of Complex Permeability of Ni-Zn Ferrite Composite Materials,” Journal of Applied Physics, Vol. 78, No. 6, 1995, pp. 3983-3991.
http://dx.doi.org/10.1063/1.359919

[27]   E. P. Wohlfarth, “Ferromagnetic Materials: A Handbook on the Properties of Magnetically Ordered Substances,” Elsevier Science, 1980.

[28]   S. V. Kakatkar, S. S. Kakatkar, R. S. Patil, A. M. Sankpal, N. D. Chaudhari, P. K. Maskar, S. S. Suryawanshi and S. R. Sawant, “Effect of Sintering Conditions and Al3+ Addition on Wall Permeability in Ni1-xZnxAltFe2-tO4 Ferrites,” Materials Chemistry and Physics, Vol. 46, 1996, pp. 96-99.
http://dx.doi.org/10.1016/0254-0584(96)01746-4

[29]   S. A. Mazen and N. I. Abu-Elsaad, “Structural and Some Magnetic Properties of Manganese-Substituted Lithium Ferrites,” Journal of Magnetism and Magnetic Materials, Vol. 324, No. 20, 2012, pp. 3366-3373.
http://dx.doi.org/10.1016/j.jmmm.2012.05.056

 
 
Top