Back
 OJSST  Vol.3 No.4 , December 2013
Numerical Modeling of the Thermal Behavior of Corrosion in Conduit in Transient Mode
Abstract: The conduits in the buildings require a regular and permanent control, in order to avoid the risks of deterioration caused by corrosion. In this paper we present a thermal nondestructive testing method of concrete structures containing a conduit system, based on the analysis by infrared thermography principle and the numerical modeling in three dimensions. The aim is to study the detectability of these pipes in different situations versus time and to give a thermal characterization of the rust behavior in the transitory mode.
Cite this paper: N. Laaidi and S. Belattar, "Numerical Modeling of the Thermal Behavior of Corrosion in Conduit in Transient Mode," Open Journal of Safety Science and Technology, Vol. 3 No. 4, 2013, pp. 109-115. doi: 10.4236/ojsst.2013.34014.
References

[1]   Y. Zhao, J. Yu, Y. Wu and W. Jin, “Critical Thickness of Rust Layer at Inner and Out Surface Cracking of Con- crete Cover in Reinforced Concrete Structures,” Corrosion Science, Vol. 59, 2012, pp. 316-323.
http://dx.doi.org/10.1016/j.corsci.2012.03.018

[2]   F. J. Molina, C. Alonso and C. Andrade, “Cover Cracking as a Function of Rebar Corrosion: Part 2 Numerical model,” Materials and Structures, Vol. 26, No. 9, 1993, pp. 532-548. http://dx.doi.org/10.1007/BF02472864

[3]   K. Bhargavaa, A. K. Ghoshb, Y. Moric and S. Ramanujama, “Model for Cover Cracking Due to Rebar Corrosion in RC Structures,” Engineering Structures, Vol. 28, No. 8, 2006, pp. 1093-1109.
http://dx.doi.org/10.1016/j.engstruct.2005.11.014

[4]   S. Marinetti and V. Vavilov, “IR Thermographic Detection and Characterization of Hidden Corrosion in Metals: General Analysis,” Corrosion Science, Vol. 52, No. 3, 2010, pp. 865-872.
http://dx.doi.org/10.1016/j.corsci.2009.11.005

[5]   M. Weiser, M. Rollig, R. Arndt and B. Erdmann, “Development and Test of a Numerical Model for Pulse Thermography in Civil Engineering,” Heat Mass Transfer, Vol. 46, No. 11-12, 2010, pp. 1419-1428.
http://dx.doi.org/10.1007/s00231-010-0656-9

[6]   M. R. Clark, D. M. McCann and M. C. Forde, “Application of Infrared Thermography to the Non-Destructive Testing of Concrete and Masonry Bridges,” NDT&E International, Vol. 36, No. 4, 2003, pp. 265-275.
http://dx.doi.org/10.1016/S0963-8695(02)00060-9

[7]   T. Sakagami and S. Kubo, “Development of a New Non-Destructive Testing Technique for Quantitative Eva- luations of Delamination Defects in Concrete Structures Based on Phase Delay Measurement Using Lock-In Ther- mography,” Infrared Physics & Technology, Vol. 43, No. 3-5, 2002, pp. 311-316.
http://dx.doi.org/10.1016/S1350-4495(02)00157-3

[8]   H. Wiggenhauser, “Active IR-Applications in Civil Engineering,” Infrared Physics & Technology, Vol. 43, No. 3-5, 2002, pp. 233-238.
http://dx.doi.org/10.1016/S1350-4495(02)00145-7

[9]   N. Laaidi and S. Belattar, “Application of Thermal Non Destructive Testing Method to Oil Conduits Control,” 5th Pan American Conference for NDT, Cancun, 2-6 October 2011.

[10]   N. Laaidi and S. Belattar, “Modeling of Damages in the Bridges,” The 10th International Conference of the Slovenian Society for Non-Destructive Testing “Application of Contemporary Non-Destructive Testing in Engineering”, 1-3 September 2009, Ljubljana, 2009, pp. 149-158.

[11]   N. Laaidi and S. Belattar, “The Numerical Modeling and the Infrared Thermography Principle Applied to the Analysis of Corrosion Defects in Oil Conduits,” QIRT 2012, ID-114.

[12]   N. Laaidi and S. Belattar, “Damages in the Bridges. Modeling and Analysis of Defects of Cracks and Corrosion Type,” Simulation in NDT, Online Workshop, 2010.
www.ndt.net

[13]   Y. Yuang, Y. Ji and J. Jiang, “Effect of Corrosion Layer of Steel Bar in Concrete on Time-Variant Corrosion Rate,” Materials and Structures, Vol. 42, No. 10, 2009, pp. 1443-1450.
http://dx.doi.org/10.1617/s11527-008-9464-9

[14]   Ch. Maierhofer, R. Arndt, M. Rollig, C. Rieck, A. Wal- ther, H. Scheel and B. Hillemeier, “Application of Impulse-Thermography for Non-Destructive Assessment of Concrete Structures,” Cement & Concrete Composites, Vol. 28, No. 4, 2006, pp. 393-401.
http://dx.doi.org/10.1016/j.cemconcomp.2006.02.011

[15]   CH. Cheng, T. Ming Cheng and C. H. Hung Chiang, “Defect Detection of Concrete Structures Using Both Infrared Thermography and Elastic Waves,” Automation in Construction, Vol. 18, No. 1, 2008, pp. 87-92.
http://dx.doi.org/10.1016/j.autcon.2008.05.004

[16]   M. Dekoster, O. Blanpain, F. Buyle-Bodin and O. Maurel, “Etude de l’Evolution des Coefficients de Sécurité des Ouvrages en Béton Armé Dégradé selon Différents Scénarios de Corrosion,” XXIIiemes Rencontres Universitaires de Génie Civil, Ville & Genie Civil, 2004.

[17]   Q. T Nguyen, S. Caré, Y. Berthaud and A. Millard, “Analyse de la Fissuration du Béton Armé en Corrosion Accélérée,” Comptes Rendus Mécanique, Vol. 335, No. 2, 2007, pp. 99-104.
http://dx.doi.org/10.1016/j.crme.2007.01.005

[18]   E. Grinzato, V. Vavilov and T. Kauppinen, “Quantitative Infrared Thermography in Buildings,” Energy and Buildings, Vol. 29, No. 1, 1998, pp. l-9.
http://dx.doi.org/10.1016/S0378-7788(97)00039-X

[19]   Y. He, G. Tian, L. Cheng, H. Zhang and P. Jackson, “Parameters Influence in Steel Corrosion Evaluation Using PEC Thermography,” Proceedings of the 17th International Conference on Automation & Computing, Huddersfield, 10 September 2011.

[20]   A. Elballouti and S. Belattar, “Thermal Non-Destructive Characterisation of Layers Detachment in the Roadways,” Int. J. of Materials and Product Technology, 2011, 4117-26.

[21]   N. Laaidi, S. Belattar and A. Elballouti, “Pipeline Corrosion, Modeling and Analysis,” Journal of Nondestructive Evaluation, Vol. 30, No. 3, 2011, pp. 158-163.
http://dx.doi.org/10.1007/s10921-011-0103-y

[22]   W. B. J. Zimmerman, “Process Modelling and Simulation with Finite Element Methods, World Scientific Series on Stability, Vibration and Control of Systems,” Series A. Singapore, 2004.

[23]   C. H. Maierhofer, A. Brink, M. Rollig and H. Wiggenhausser, “Quantitative Impulsethermography as Non-Destructive Testing Method in Civil Engineering—Experimental Results and Numerical Simulations,” Construction and Building Materials, Vol. 19, No. 10, 2005, pp. 731-737. http://dx.doi.org/10.1016/j.conbuildmat.2005.06.002

 
 
Top