JPEE  Vol.1 No.6 , November 2013
Circuit Model of 100 Ah Lithium Polymer Battery Cell
Abstract: This paper presents a circuit model for a 100 Ah Lithium Polymer Battery that takes into account the effect of temperature and discharge rates. This is done by studying the behavior of two advanced 100 Ah Lithium Polymer Battery cells under different load condition and at different temperatures, to extract the RC parameters needed to develop the equivalent circuit model. This paper presents a methodology to identify the several parameters of the model. The parameters of the circuit model depend on both, battery cell temperature and discharging current rate. The model is validated by comparing simulation results with experimental data collected through battery cell tests. The simulation results of the battery cell model are obtained using MATLAB, and the experimental data are collected through the battery test system at battery evaluation lab at University of Massachusetts Lowell. This model is useful for optimization of the battery management system which is needed to run a battery bank safely in an electric car.
Cite this paper: Kim, B. , Patel, D. and Salameh, Z. (2013) Circuit Model of 100 Ah Lithium Polymer Battery Cell. Journal of Power and Energy Engineering, 1, 1-8. doi: 10.4236/jpee.2013.16001.

[1]   Z. M. Salameh and B. G. Kim, “Advanced Lithium Polymer Batteries,” IEEE Power and Energy Society General Meeting, July 26-30, 2009, Calgary, pp. 1-5.

[2]   Z. M. Salameh, M. A. Casacca and W. A. Lynch, “A Mathematical Model for Lead-Acid Batteries,” IEEE Transaction on Energy Conversion, Vol. 7, No. 1, 1992, pp. 93-97.

[3]   W. A. Lynch and Z. M. Salameh, “Electrical Component Model for a Nickel-Cadmium Electric Vehicle Traction Battery,” IEEE Power and Energy Society General Meeting, June 18-22, 2006, Montreal.

[4]   M. Knauff, J. McLaughlin, C. Dafis, D. Niebur, P. Singh , H. Kwatny and C. Nwankpa, “Simulink Model of a Lithium-Ion Battery for the Hybrid Power System Test Bed,” IEEE Electric Ship Technologies Symposium, May 21-23, 2007, Arlington, pp. 421-427.

[5]   M. Chen and G. A. Rincon-Mora, “Accurate Electrical Battery Model Capable of Predicting Runtime and I-V Performance,” IEEE Transaction on Energy Conversion, Vol. 21, No. 2, 2006, pp. 504-511.

[6]   J. C. Zhang, S. Ci and H. Sharif, “An Enhanced Circuit-Based Model for Single-CellBattery,” IEEE Applied Power Electronic Conference and Exposition (APEC), February 21-25, 2010, Palm Springs, pp. 672-675.

[7]   B. G. Kim, F. P. Tredeau and Z. M. Salameh, “Performance Evaluation of Lithium Polymer Batteries for Use in Electric Vehicles,” IEEE Vehicle Power and Propulsion Conference (VPPC), September 3-5, 2008, Harbin, pp. 1-5.