Back
 EPE  Vol.5 No.4 B , July 2013
Study on Operating Characteristics of Power Plant with Dry and Wet Cooling Systems
Abstract: The represent paper will study the performance of the power plant with the combination of dry and wet cooling systems in different operating conditions. A thermodynamic performance analysis of the steam cycle system was performed by means of a program code dedicated to power plant modeling in design operating condition. Then the off-design behavior was studied by varying not only the ambient temperature and relative humidity but also several parameters connected to the cooling performance, like the exhaust steam flow rate, the air cooling fan load and the number of operating cooling water pumps and cooling towers. The result is an optimum set of variables allowing the dry and wet cooling system be regulated in such a way that the maximum power is achieved and low water consumption.
Cite this paper: T. Tang, J. Xu, S. Jin and H. Wei, "Study on Operating Characteristics of Power Plant with Dry and Wet Cooling Systems," Energy and Power Engineering, Vol. 5 No. 4, 2013, pp. 651-656. doi: 10.4236/epe.2013.54B126.
References

[1]   E. Ding, “Air Cooling Technology in Power Plant,” M, Beijing: China Water Power Press, 1992 (in Chinese).

[2]   J. A. Heyns, “Performance Characteristics of an Air-cooled Steam Condenser Incorporating a Hybrid (dry/wet) Dephlegmator,” D, Depart of Mechanical Engineering, Uniwersity of Stellenbosch, 2008.

[3]   P. Lindahl and R.W. Jameson, “Plume abatement and water conservation with wet/dry cooling towers,” CTI Journal, Vol. 14, No. 2, 1993.

[4]   D. G. KrÖger, “Air-cooled Heat Exchanger and Cooling Towers,” USA: Penwell Corp, Tulsa, 2004.

[5]   F. W. Yu and K. T. Chan, “Application of Direct Evaporative Coolers for Improving the Energy Efficiency of Air-cooling Chillers,” Journal of solar Energy Engineering, Vol. 127, No. 3, 2005, pp. 430-433. doi:10.1115/1.1866144

[6]   L. X. Zhou, et al, “Study on Variable Condition Features for 300 MW Direct Air-cooling Unit,” J, Proceedings of the CSEE, Vol. 27, No. 17, 2007, pp. 78-82.

[7]   S. P. Fisenko and A.I. Petruchik, “Toward to the Control System of Mechanical Draft Cooling Tower of Film Type,” Int J Heat Mass Transfer, 2005, Vol. 47, pp. 31-35. doi:10.1016/j.ijheatmasstransfer.2004.08.002

[8]   J. Pisko-rowski, R. B. G. Beekett, “Condenser Perofrmanee Test and Baek-Pressure lmProvement,” EPRI, CS.5729, Vol. 4, 1988, pp. 19-23.

[9]   A. A. Brin, A. I. Petruchik, S. P. Fisenko, “Mathematical Modeling of Evaporative Cooling of Water in a Mechanical-draft Tower,” Journal of Engineering Physics and Thermophysics, Vol. 75, No. 6, 2002, pp. 1332-1338. doi:10.1023/A:1022110809044

 
 
Top