Fractured, very permeable rock hosting repositories for radioactive waste will require grouting. New grout types of possible use where long-term performance is needed should have a small amount of cement for minimizing the increase in porosity that will follow from the ultimate dissolution and erosion of this component. They have to be low-viscous and gain strength early after injection and packing theory can assist designers in selecting suitable proportions of various grout components. Optimum particle packing means that the porosity is at minimum and that the amount of cement paste needed to fill the voids between aggregate particles is very small. Low porosity and microstructural stability must be guaranteed for long periods of time. Organic additives for reaching high fluidity cannot be used since they can give off colloids that carry released radionuclides and talc can be an alternative superplasticizer. Low-pH cement reacts with talc to give high strength with time while Portland cement gives early but limited strengthening. The clay mineral palygorskite can be used for early gelation because of its thixotropic properties. Once forced into the rock fractures or channels in soil it stiffens and serves as a filter that prevents fine particles to migrate through it be lost. However, its hydrophilic potential is too high to give the grout a high density and high strength. According to the experiments carried out, most of the investigated grouts are injectable in fractures with apertures down to 100 μm.
 G. S. Littlejohn, “The Development of Practice in Per meation and Compensation Grouting: A Historical Re view (1802-2002),” Proceedings of the 3rd International Conference on Grouting and Ground Treatment, New Orleans, 10-12 February 2003, Geotechnical Special Pub lication No. 120, pp. 50-100. http://dx.doi.org/10.1061/40663(2003)3
 R. Pusch, M. H. Mohammed, J. Kasbohm and S. Knuts son, “Roles of Clay and Concrete in Isolating High-Level Radioactive Waste in Very Long Holes,” International Journal of Research Reviews in Applied Sciences, Vol. 16, No. 2, 2013, in press.
 R. Pusch, L. Warr, G. Grathoff, A. Purbakhtiar, S. Knuts son and M. H. Mohammed, “A Talc-Based Cement-Poor Concrete for Sealing Boreholes in Rock,” Engineering, Vol. 5, No. 3, 2013, pp. 251-267. http://dx.doi.org/10.4236/eng.2013.53036
 R. Pusch, G. Ramqvist, S. Knutsson and M. H. Moham med, “Medium-Deep or Very Deep Disposal of Highly Radioactive Waste?” Journal of Civil Engineering and Architecture, 2013, accepted for publication.
 R. Pusch, G. Ramqvist, S. Knutsson and M. H. Moham med, “The Concept of Highly Radioactive Waste (HLW) Disposal in Very Deep Boreholes in a New Perspec tive,” Journal of Earth Sciences and Geotechnical Engineering, Vol. 2, No. 3, 2012, pp. 1-24.
 A. Fransson, “Grouting Design Based on Characterization of the Fractured Rock Presentation and Demonstration of a Methodology,” SKB Report, Sweco Environment and Chalmers University of Technology, Sweden, 2008.
 A. Pourbakhtiar, “Pilot Study of Method for Constructing Concrete Seals and Fracture Grouts in Deep Boreholes and Cementitious Backfills in Tunnels, Drifts and Shafts in Crystalline Rock,” Master Thesis, Lulea University of Technology, Lulea, 2012.
 R. Pusch, “Geological Storage of Highly Radioactive Waste,” Springer, 2008.
 M. H. Mohammed, R. Pusch, N. Al-Ansari, S. Knutsson, M. Emborg, M. Nilsson and A. Pourbakhtiar, “Talc Based Concrete for Sealing Borehole Optimized by using Particle Packing Theory,” Journal of Civil Engineering and Architecture, Vol. 7, No. 4, 2013, pp. 440-455.
 M. H. Mohammed, M. Emborg, R. Pusch and S. Knuts son, “Packing Theory for Natural and Crushed Aggregate to Obtain the Best Mix of Aggregate: Research and De velopment,” Proceedings of WASET, International Con ference on Civil and Construction Engineering, Vol. 67, No. 150, pp. 819-825.
 Teknologisk Institut, The Danish Technological Institute, 2012. http://www.danishtechnology.dk
 T. Stovall, F. DeLarrard and M. Buil, “Linear Packing Density Model of Grain Mixtures,” Powder Technology, Vol. 48, No. 1, 1986, pp. 1-12. http://dx.doi.org/10.1016/0032-5910(86)80058-4
 M. H. Mohammed, R. Pusch, N. Al-Ansari and S. Knuts son, “Optimization of Concrete by Minimizing Void Vol ume in Aggregate Mixture System,” Journal of Advanced Science and Engineering Research, Vol. 2, No. 3, 2012, pp. 208-222.