OJCE  Vol.3 No.3 , September 2013
Approach to Determine Corrosion Propensity in Post-Tensioned Tendons with Deficient Grout
ABSTRACT

After corrosion failure of post-tensioned tendons was identified in a Florida bridge in early 2011, laboratory tests were conducted in this study on extracted sections from the failed tendons to identify the grout properties and makeup leading to the failure and also to elucidate the mechanism of corrosion. The initial steps in identification of PT tendons with a high propensity for corrosion initiation or damaged included a detailed visual inspection and identification of voids in the grout. Voids in tendon can be a result of bleed water formation or construction problems. General characteristics of the deficient grout and corrosion behavior of steel in the affected bridge gave a first approach to assessing grout deficiency and corrosion susceptibility. However, refinements in the understanding of the mechanisms causing grout segregation and the elucidation of the role of sulfates, oxygen content, and pore water pH in corrosion development are required.


Cite this paper
J. Rafols, K. Lau, I. Lasa, M. Paredes and A. ElSafty, "Approach to Determine Corrosion Propensity in Post-Tensioned Tendons with Deficient Grout," Open Journal of Civil Engineering, Vol. 3 No. 3, 2013, pp. 182-187. doi: 10.4236/ojce.2013.33022.
References
[1]   A. Sagues, R. Powers and H. Wang, “Mechanism of Corrosion of Steel in Post Tensioned Grouted Assemblies,” NACE Corrosion, Houston, 2003.

[2]   W. Hartt and S. Venugopalan, “Corrosion Evaluation of Post-Tensioned Tendons on the Mid Bay Bridge in Destin, FL.,” Florida Department of Transportation Research Center, Tallahassee, 2002.

[3]   Corven Engineering Inc., “New Directions for Florida Post-Tensioned Bridges,” Florida Department of Transportation, Tallahassee, 2002.

[4]   K. Lau, I. Lasa, M. Paredes and J. C. Rafols, “Laboratory Corrosion Assessment of Post-Tensioned Tendons Repaired with Dissimilar Grout,” NACE Corrosion, Houston, 2013.

[5]   D. Trejo, S. B. Im, R. G. Pillai, M. B. D. Hueste, P. Gardoni, S. Hurlebaus and M. Gamble, “Effect of Voids in Grouted Post-Tesioned Concrete Bridge Construction: Inspection and Repair Manual for External Tendons in Segmental, Post-Tensioned Bridges,” Texas Transportation Institute, Austin, 2009.

[6]   J. C. Rafols, “Corrosion of Post-Tensioned Tendons Repaired with Dissimilar Grout,” Unplublished Master’s Thesis, University of North Florida, Jacksonville, 2012.

[7]   M. M. Sprinkel, “Varina Enon Tendon Failure,” Virginia Transportation Research Council, Charlottesville, 2009.

[8]   M. Eriksson, M. Friederich and C. Vorschulze, “Variations in the Rheology and Penetrability of Cement-Based Grouts—An Experimental Study,” Cement and Concrete Research, Vol. 34, No. 7, 2004, pp. 1111-1119. doi:10.1016/j.cemconres.2003.11.023

[9]   K. Lau and A. Sagues, “Coating Conditions Evaluation of Epoxy Coated Rebars,” ECS Transactions, Vol. 3, No. 13, 2007, pp. 81-92. doi:10.1149/1.2721432

[10]   K. Lau, M. Paredes and J. C. Rafols, “Corrosion Evaluation of Post-Tensioned Tendons with Dissimillar Grout,” NACE Corrosion, Salt Lake City, 2012.

[11]   A. Bentur, S. Diamond and N. Berke, “Steel Corrosion in Concrete, Fundametals and Civil Engineering Practice,” E & FN Spon, London, 1997.

[12]   R. Barneyback and S. Diamond, “Expression and Analysis of Pore Fluids from Hardened Cement Pastes and Mortars,” Cement and Concrete Research, Vol. 11, No. 2, 1981, pp. 279-285.
doi:10.1016/0008-8846(81)90069-7

[13]   L. Li, J. Nam and W. H. Hartt, “Ex Situ Leaching Measurement of Concrete Alkalinity,” Cement and Concrete Research, 2004, pp. 1-7.

[14]   Corven Engineering, Inc., “Mid-Bay Bridge Post-Tensioning Evaluation,” Florida Department of Transportation, Tallahassee, 2001.

[15]   S. K. Lee, “Bridge Deterioration: Part 2—Bridge Deterioration Caused by Corrosion,” Materials Performance Journal, Vol. 51, No. 2, 2012, pp. 2-7.

[16]   S. K. Lee, “Literature Review of Chloride Threshold Values of Grouted Post-Tensioned Tendons,” Federal Highway Administration, FHWA-HRT-12-067, McLean, 2012.

[17]   H. Wang and A. Sagues, “Corrosion of Post-Tensioning Strand,” Florida Department of Transportation, Tallahassee, 2005.

[18]   O. Al-Amoudi and M. Maslehuddin, “The Effect of Chloride and Sulfate Ions on Reinforcement Corrosion,” Cement and Concrete Research, Vol. 23, No. 1, 1993, pp. 139-146. doi:10.1016/0008-8846(93)90144-X

[19]   V. K. Gouda and W. Y. Halaka, “Corrosion and Corrosion Inhibition of Reinforcing Steel: II. Embeded in Concrete,” British Corrosion Journal, Vol. 5, No. 5, 1970, pp. 204-208.
doi:10.1179/000705970798324478

[20]   L. Bertolini and M. Carsana, “High pH Corrosion of Prestressing Steel in Segregated Grout,” Dipartimento di Chimica, Materiali e Ingegneria Chimica “G. Natta”, Politecnico di Milano, Milano, 2011.

[21]   H. W. Song and V. Saraswathy, “Corrosion Monitoring of Reinforced Concrete Structures—A Review,” International Journal of Electrochemical Science, Vol. 2, No. 1, 2007, pp. 1-28.

[22]   D. A. Jones, “Principles and Prevension of Corrosion,” 2nd Edition, Prentice Hall, New Jersey, 1996.

[23]   M. Hansson, A. Poursaee and S. Jaffer, “Corrosion of Reinforcing Bars in Concrete,” Portland Cement Association, Skokie, 2007.

[24]   N. J. Crammond, “Quantitative X-Ray Diffraction of Ettringite, Thaumasite and Gypsum in Concretes and Mortars,” Cement and Concrete Research, Vol. 15, No. 3, 1985, pp. 431-441. doi:10.1016/0008-8846(85)90116-4

[25]   Portland Cement Association, “The Effect of Secondary Ettringite Formation on the Durability of Concrete: A Literature Analysis,” Portland Cement Association, 1992.

[26]   A. Sagues, “Corrosion Measurement Techniques for Steel in Concrete,” NACE Corrosion, Houston, 1993.

[27]   J. A. González, J. M. Miranda, N. Birbilis and S. Feliu, “Electrochemical Techniques for Studying Corrosion of Reinforcing Steel: Limitations and Advantages,” Corrosion Journal, Vol. 61, No. 1, 2005, pp. 37-50.

[28]   E. Barsoukov and J. Macdonald, “Impedance Spectroscopy Theory, Experiment, and Applications,” Wiley-Interscience, New Jersey, 2005.

[29]   B. Hope and A. Ip, “Corrosion and Electrical Impedance in Concrete,” Cement and Concrete Research, Vol. 15, No. 3, 1985, pp. 525-534. doi:10.1016/0008-8846(85)90127-9

 
 
Top