JEP  Vol.4 No.8 , August 2013
Remediation of Heavy Metal (Cd, Cr, Cu, Co, and Ni) Ions from Kaolinite Clay Using Molecular Micelles Chelators and D-Optimum Experimental Design
Abstract: This study investigated the potential utility of poly (sodium N-undecanoyl-L-leucyl-valinate) (poly-L-SULV), poly (sodium N-undecanoyl-L-leucyl-alanate) (poly-L-SULA), and poly (sodium N-undecanoyl-glycinate) (poly-SUG) molecular micelles (MMs) as chelators for heavy metal (Cd, Cr, Cu, Co, and Ni) ion remediation of kaolinite clay using D-optimum experimental design. D-optimum experimental design was employed to simultaneously investigate the influence of design variables such as the buffer pH, chelator concentration, and centrifuge speed to evaluate the optimum conditions and to reduce the time and cost of metal ion remediation. The partition coefficients of the metal ion concentrations between the kaolinite clay and chelator equilibrium were also evaluated. In addition, the influence of metal ion concentrations on the remediation capability of the chelators was evaluated by conducting remediation studies at four different (10 ppm, 40 ppm, 60 ppm, and 80 ppm) metal ion concentrations. In general, the results of the remediation efficiency and partition coefficients obtained in this study are highly metal ion dependent and also dependent upon the chelator used for the remediation. Specifically, the remediation efficiency of the molecular micelles was found to be comparable to or better than the corresponding remediation efficiency obtained when SDS or EDTA was used for the remediation. However, at optimum conditions, poly-SULV and poly-L-SULA molecular micelle chelators demonstrated superior remediation efficiencies for Cr, with remediation efficiency of 99.9 ± 8.7% and 99.1 ± 0.7%, respectively.
Cite this paper: S. Fakayode, A. Taylor, M. McCoy, S. Owen, W. Stapleton, C. Grady and D. Pollard, "Remediation of Heavy Metal (Cd, Cr, Cu, Co, and Ni) Ions from Kaolinite Clay Using Molecular Micelles Chelators and D-Optimum Experimental Design," Journal of Environmental Protection, Vol. 4 No. 8, 2013, pp. 789-795. doi: 10.4236/jep.2013.48092.

[1]   G. U. Adie and O. Osibanjo, “Accumulation of Lead and Cadmium by Four Tropical Forage Weeds Found in the Premises of an Automobile Battery Manufacturing Company in Nigeria,” Toxicology and Environmental Chemistry, Vol. 92, No. 1, 2010, pp. 39-49. doi:10.1080/02772240902918337

[2]   S. O. Fakayode and B. I.Olu-Owolabi, “Heavy Metal Contamination of Roadside Topsoil in Osogbo, Nigeria: Its Relationship to Traffic Density and Proximity to Highways,” Environmental Geology, Vol. 44, No. 2, 2003, pp. 150-157.

[3]   S. O. Fakayode and P. C. Onianwa, “Heavy Metal Contamination of Soil, and Bioaccumulation in Guinea Grass (Panicum maximum) around Ikeja Industrial Estate, Lagos, Nigeria,” Environmental Geology, Vol. 43, No. 1-2, 2002, pp. 145-150. doi:10.1007/s00254-002-0633-9

[4]   S. Fontana, M. Wahsha and C. Bini, “Preliminary Observations on Heavy Metal Contamination in Soils and Plants of an Abandoned Mine in Imperina Valley (Italy),” Agrochimica, Vol. 54, No. 4, 2010, pp. 218-231.

[5]   Z. Yang, W. Lu, Y. Long, X. Bao and Q. Yang, “Assessment of Heavy Metals Contamination in Urban Topsoil from Changchun City, China,” Journal of Geochemical Exploration, Vol. 108, No. 1, 2011, pp. 27-38. doi:10.1016/j.gexplo.2010.09.006

[6]   O. J. Okunola, A. Uzairu, G. I. Ndukwe and S. G. Adewusi, “Assessment of Cd and Zn in Roadside Surface Soils and Vegetations along Some Roads of Kaduna Metropolis, Nigeria,” Journal of Environmental Science, Vol. 2, No. 4, 2008, pp. 266-274.

[7]   Agency for Toxic Substances and Diseases Registry (ASTDR), “Toxicological Profile for Lead,” US Department of Health and Human Services, Public Health Services, 2009.

[8]   S. Tong, Y. E. von Schirnding and T. Prapamontol, “Environmental, Lead Exposure: A Public Health Problem of Global Dimensions,” Bulletin of World Health Organization, Vol. 78, No. 9, 2000, pp. 1068-1077.

[9]   W. Chen, L. Hsiao and K. K. Chen, “Metal Desorption from Copper(II)/Nickel(II)-Spiked Kaolin as a Soil Component Using Plant-derived Saponin Biosurfactant,” Process Biochemistry, Vol. 43, No. 5, 2008, pp. 488-498. doi:10.1016/j.procbio.2007.11.017

[10]   M. W. Amer, F. I. Khalili and A. M. Awwad, “Adsorption of Lead, Zinc and Cadmium Ions on Polyphosphate-Modified Kaolinite Clay,” Journal of Environmental Chemistry and Ecotoxicology, Vol. 2, No. 1, 2010, pp. 1-8.

[11]   B. I. Olu-Owolabi and E. I. Unuabonah, “Adsorption of Zn2+ and Cu2+ onto Sulphate and Phosphate-Modified Bentonite,” Applied Clay Science, Vol. 51, No. 1-2, 2011, pp 170-173. doi:10.1016/j.clay.2010.10.022

[12]   E. I. Unuabonah, B. I. Olu-Owolabi, K. O. Adebowale and L. Z. Yang, “Removal of Lead and Cadmium Ions from Aqueous Solution by Polyvinyl Alcohol-Modified Kaolinite Clay: A Novel Nano-Clay Adsorbent,” Adsorption Science and Technology, Vol. 26, No. 6, 2008, pp. 383-405. doi:10.1260/0263-6174.26.6.383

[13]   W. Omar and H. Al-Itawi, “Removal of Pb+2 Ions from Aqueous Solutions by Adsorption on Kaolinite Clay,” American Journal of Applied Sciences, Vol. 4, No. 7, 2007, pp 502-507. doi:10.3844/ajassp.2007.502.507

[14]   E. Repo, L. Malinen, R. Koivula, R. Harjula and M. Sillanpaa, “Capture of Co(II) from Its Aqueous EDTA-Chelate by DTPA-Modified Silica Gel and Chitosan,” Journal of Hardzadous Material, Vol. 187, No. 1-3, 2011, pp. 122-132. doi:10.1016/j.jhazmat.2010.12.113

[15]   C. M. Zvinowanda, J. O. Okonkwo, P. N. Shabalala and N. M. Agyei, “A Novel Adsorbent for Heavy Metal Remediation in Aqueous Environments,” International Journal of Environmental Science and Technology, Vol. 6, No. 3, 2009, pp. 425-434.

[16]   S. Ahmady-Asbchin, Y. Andres, C. Gerente, P. Le Cloirec, “Natural Seaweed Waste as Sorbent for Heavy Metal Removal from Solution,” Environmental Technology, Vol. 30, No. 7, 2009, pp. 755-762. doi:10.1080/09593330902919401

[17]   S. S. Ahluwalia and D. Goyal, “Microbial and Plant Derived Biomass for Removal of Heavy Metals from Wastewater,” Bioresource Technology, Vol. 98, No. 12, 2007, pp. 2243-2257. doi:10.1016/j.biortech.2005.12.006

[18]   A. Atkinson, A. Donev and R. Tobias, “Optimum Experimental Designs, with SAS (Oxford Statistical Science Series),” Oxford University Press Inc., New York, 2007,

[19]   R. K. Prasad, R. R. Kumar and S. N. Srivastava, “Design of Optimum Response Surface Experiments for Electro-Coagulation of Distillery Spent Wash,” Water, Air, Soil Pollution, Vol. 191, No. 1-4, 2008, pp. 5-13. doi:10.1007/s11270-007-9603-x

[20]   Z. Gong, M. Zhang, A. S. Mujumdar and J. Sun, “Spray Drying and Agglomeration of Instant Bayberry Powder,” Drying Technology, Vol. 26, No. 1, 2008, pp. 116-121. doi:10.1080/07373930701781751

[21]   L. B. Dantas, H. R. B. Orlande and R. M. Cotta, “Estimation of Dimensionless Parameters of Luikov’s System for Heat and Mass Transfer in Capillary Porous Media,” International Journal of Thermal Sciences, Vol. 41, No. 3, 2002, pp. 217-227. doi:10.1016/S1290-0729(01)01310-2

[22]   A. A. Williams, S. O. Fakayode, X. Huang and I. M. Warner, “Use of Multivariate Analysis for Optimization of Separation Parameters and Prediction of Migration Time, Resolution and Resolution per Unit Time in Micellar Electrokinetic Chromatography,” Electrophoresis, Vol. 27, No. 21, 2006, pp. 4127-4140. doi:10.1002/elps.200600071

[23]   C. A. Luces, S. O. Fakayode, M. Lowry and I. M. Warner, “Protein Separations Using Experimental Design for Optimization of Separation Parameters with Polyelectrolyte Multilayer Coatings,” Electrophoresis, Vol. 29, No. 4, 2008, pp. 889-900. doi:10.1002/elps.200700634

[24]   G. M. Ganea, C. M. Sabliov, A. O. Ishola, S. O. Fakayode and I. M. Warner, “Experimental Design and Multivariate Analysis for Optimizing Poly (D,L-Lactide-co-Glycolide) (PLGA) Nanoparticle Synthesis Using Molecular Micelles,” Journal of Nanoscience and Nanotechnology, Vol. 8, No. 1, 2008, pp. 280-292.

[25]   O. Anurukvorakun, W. Suntornsuk and L. Suntornsuk, “Factorial Design Applied to a Non-Aqueous Capillary Electrophoresis Method for the Separation of β-Agonists,” Journal of Chromatography A, Vol. 1134, No. 1-2, 2006, pp. 326-332. doi:10.1016/j.chroma.2006.09.021

[26]   N. De la Cruz-Landero, V. E. Hernandez, E. Guevara, M. A. Lopez-Lopez, A. T. Santos, E. Ojeda-Trejo, A. Alderete-Chavez and A. Lupinus, “Versicolor Response in Soils Contaminated with Heavy Metals from a Petroleum Extraction Field,” Journal of Applied Science, Vol. 10, No. 8, 2010, pp. 694-698. doi:10.3923/jas.2010.694.698

[27]   J. Wang and I. M. Warner, “Chiral Separations Using Micellar Electrokinetic Capillary Chromatography and a Polymerized Chiral Micelle,” Analytical Chemistry, Vol. 66, No. 21, 1994, pp. 3773-3776. doi:10.1021/ac00093a037

[28]   F. H. Billiot, E. J. Billiot and I. M. Warner, “Comparison of Monomeric and Polymeric Amino Acid Based Surfactants for Chiral Separations,” Journal of Chromatography A, Vol. 922, No. 1-2, 2001, pp. 329-338. doi:10.1016/S0021-9673(01)00865-2

[29]   A. Dube, R. Zbytniewski, T. Kowalkowski, E. Cukrowska and B. Buszewski, “Adsorption and Migration of Heavy Metals in Soil,” Polish Journal of Environmental Studies, Vol. 10, No. 1, 2001, pp. 1-10.

[30]   P. Srivastava, B. Singh and M. J. Angove, “Competitive Adsorption of C(II) onto Kaolinite as Affected by pH,” 3rd Australian New Zealand Soils Conference, Sydney, 5-9 December 2004, pp. 5-9.

[31]   V. Chantawong, N. W. Harvey and V. N. Bashkin, “Comparison of Heavy Metal Adsorptions by Thai Kaolin and Ballclay,” Water, Air, Soil Pollution, Vol. 148, No. 1-4, 2003, pp. 111-125. doi:10.1023/A:1025401927023