MME  Vol.3 No.2 , May 2013
The Influence Factors Study of Aerosol Particles
Author(s) Tao Jiang*, Wu Wei
ABSTRACT

The marine and coastal intake filtration device is mainly used to filter out the salt spray aerosol particles. So, the laboratory studies of the intake filtration device need to simulate the salt spray aerosols state of the ocean environment. But the distribution of ocean salt spray aerosol particle of diameter is very wide, so the simulation device of salt spray aersol should produce a variety of salt spray aerosol particles. The paper is to mainly study the influencing factors of salt spray aerosol device to produce different particles diameter. And the investigation and study mainly include two aspects: numerical simulation and experimental study.


Cite this paper
T. Jiang and W. Wei, "The Influence Factors Study of Aerosol Particles," Modern Mechanical Engineering, Vol. 3 No. 2, 2013, pp. 98-103. doi: 10.4236/mme.2013.32014.
References
[1]   P. Aeroso, “Measurement, Priciples, Technologies, and Applications,” Chemical Industry Press, Beijing, 2007.

[2]   Z. Z. Han, “FLUENT Fluid Simulation Examples and Application,” Beijing Institute of Technology Press, Beijing, 2004.

[3]   F. J. Wang, “Computational Fluid Dynamics Analysis,” Tsinghua Press, Beijing, 2004.

[4]   L. J. Wang, “Study of High Pressure Water Mist Nozzle and Fire Extinguishing Performance,” Huazhong University of Science and Technology, Wuhan, 2005.

[5]   D. F. Che, “A Number of Flow and Its Application,” Xi’an Jiao Tong University Press, Xi’an, 2007.

[6]   J. Cai, “Air filter ABC,” China Building Industry Press, Beijing, 2002.

[7]   D. X. Cheng, “Mechanical Design Manual,” Chemical Industry Press, Beijing, 1969.

[8]   Q. L. Hui, “Wind Tunnel Testing,” National Defence Industry Press, Beijing, 2000.

[9]   L. Y. Hou and X. C. Hou, “Nozzle Technology Handbook,” Sinopec Press, Beijing, 2002.

[10]   C. Wu, X. Y. Zhou and G. W. Wu, “Eddy Pressure Nozzle and Its Application in Spray Granulation in Fluidized Bed,” Chemical Equipment Technology, Vol. 24, No. 2, 2003, pp. 4-7.

 
 
Top