OJPC  Vol.3 No.1 , February 2013
Effect of Surfactant Concentration on Aqueous LiBr Solution Absorption Rate
Abstract: It is well known that small amounts of surfactants, such as 1-Octanol, in the aqueous solution can increase the absorption rate significantly. In this paper, experimental data were obtained for absorption of water vapour into an aqueous LiBr solution with different concentrations of 1-Octanol. An experimental rig was specifically designed and developed in this work in order to investigate the effect of surfactant (1-Octanol) on the enhancement of the heat and mass transfer in the absorption process, in addition to, the investigation of the impact of the use of magnetic stirrer inside the absorber. The experimental rig for this study was based on the refrigeration mode of the intermittent vapour absorption system. In order to study the heat and mass transfer in water-lithium bromide vapour absorption air conditioning systems, it was necessary to monitor the concentration of the solution continuously. As a consequence, two procedures for obtaining the LiBr solution concentration were used. The first method was based on the measurement of the density and temperature of the solution, while the second was based on its electrolyte conductivity and the temperature. The experimental results showed that the surfactant concentration has a significant effect on the absorption rate; this is called the Marangoni instability. It has been concluded that, in order to clarify the absorption enhancement phenomenon, it is necessary to understand the physicochemical aspects of the absorption process and the effect of surfactants on the enhancement of such process. Additionally, it has been concluded that new approaches are needed to explain the observed behaviour.
Cite this paper: A. F. Elsafty, "Effect of Surfactant Concentration on Aqueous LiBr Solution Absorption Rate," Open Journal of Physical Chemistry, Vol. 3 No. 1, 2013, pp. 1-6. doi: 10.4236/ojpc.2013.31001.

[1]   K. E. Herold, R. Raermacher and S. A. Klein, “Absorption Chillers and Heat Pumps,” CRC Press, New York, 1996.

[2]   R. K. Horn, “Determination of Concentration in Lithium-Bromide Refrigeration Cycles by Measurement of the Electrolytic Conductivity or Density,” Progress in Refrigeration Science Technology: Proceedings of International Congress Refrigeration, Vol. 2, 1969, pp. 317-328.

[3]   A. F. Elsafty, R. Al-Samarraie and A. J. Al-Daini, “Concentration Measurement in Aqueous Lithium-Bromide Solution,” World Renewable Energy Congress, Brighton, 2000.

[4]   D. R. Lide and Kehiaian, “CRC Handbook of Thermophysical and Thermochemical Data,” CRC Press, Boca Raton, 1994.

[5]   C. H. Hamann, A. Hamnett and W. Vielstich, “Electrochemistry,” Wiley-Vch., Weinheim, 1998, pp. 13-65.

[6]   W. Del Cul, J. Braunstein, R. H. Reiner and H. Perez-Blanco, “Experimental Study of The Effect of Additives on Mass Transfer to an Aqueous Solution of Lithium Bromide,” National Heat Transfer Conference Minneapolis, American Society of Mechanical Engineers, 1991, pp. 1-6.

[7]   P. W. Atkins, “Physical Chemistry,” Oxford University Press, Oxford, 1990.

[8]   D.-H. Rie and T. Kashiwagi, “Computer Simulation of Vapour-Absorption Enhancement into H20/LiBr Absorbent by Marangoni Convection,” International Journal of Japan Society Mechanical Engineering, Vol. 34, No. 3, 1991, pp. 355-361.

[9]   D.-H. Rie and T. Kashiwagi, “Experimental Study of Steam Absorption Enhancement in Accordance With Interfacial Turbulence into Aqueous Solution of LiBr (The Influence of Non-Condensable Gas,” International Journal of Japan Society Mechanical Engineering, Vol. 34, No. 4, 1991, pp. 502-508.

[10]   C. Kren, H. M. Hellman and F. Ziegler, “Dynamic Surface Tension of LiBr-Solutions with Higher Alcohols as Heat-Transfer-Additives,” International Sorption Heat Pump Conference, Munich, 1999, pp. 375-380.