AMPC  Vol.2 No.4 , December 2012
Adsorption of Cu(II), Ni(II), Zn(II), Cd(II) and Pb(II) onto Kaolin/Zeolite Based- Geopolymers
ABSTRACT

This work deals with geopolymers based on local Jordanian resources, namely, kaolin and zeoltitic (phillipsite) tuff. The geopolymers were prepared from these two materials by a reaction with an alkali solution at 80oC. The research group of the present work has demonstrated in previous work that addition of zeolitic tuff to kaolin based-geopolymers increases the adsorption capacity toward Cu(II) metal ion compared to zeolite-free geopolymers, while retaining high mechanical strength. The aim of the present work is to extend our work and to study the effect of changing geopolymers components (zeolitic tuff and kaolin) on their adsorption properties toward Cu(II), Ni(II), Zn(II), Cd(II) and Pb(II) metal ions. Both isothermal and kinetic studies revealed that increasing the zeolitic tuff: kaolin ratio improves the adsorption capacity of geopolymer toward metal ions. The adsorption capacity of the geopolymers of 150: 50 zeolites: kaolin content was found to be higher than that of the raw materials themselves. The rate of adsorption of geopolymers was found to be lower than that of raw materials due to kinetic limitations imposed by the formation of geopolymerization network. The selectivity of geopolymers toward adsorption of  metal ions was found to be distinct from raw zeolite and kaolin where the adsorption onto geopolymers was found to be more preferential for small size metal ions (Cu(II), Ni(II), Zn(II)) than for large size metal ions (Pb(II), Cd(II)). The adsorption of Cu(II) and Pb(II) onto geopolymers did not decrease with competition with other metal ions, which indicates cooperative adsorption. The adsorption process of metal ions onto geopolymers was found to be reversible that indicates that metal ions are bound by physical cation exchange to the exchangeable sites of unreacted phillipsite and new amorphous geopolymer sites. Leaching of metal ions from raw kaolin was much more effective than geopolymers and zeolite because of compact structure of geopolymers.

 


Cite this paper
B. El-Eswed, M. Alshaaer, R. Ibrahim Yousef, I. Hamadneh and F. Khalili, "Adsorption of Cu(II), Ni(II), Zn(II), Cd(II) and Pb(II) onto Kaolin/Zeolite Based- Geopolymers," Advances in Materials Physics and Chemistry, Vol. 2 No. 4, 2012, pp. 119-125. doi: 10.4236/ampc.2012.24B032.
References
[1]   K.G. Bhattacharyya and S.S. Gupta. Advances in Colloid and Interface Science 140 (2008), 114-131.

[2]   P. Srivatava, B. Singh, M. Angove. J. Colloid. Interface Sci. 290 (2005) 28-38.

[3]   I. Heidmann, I. Christl, C. Leu, R. Kretzschmar. J. Colloid. Interface Sci. 282 (2005) 270-282.

[4]   Ahmed Alfara, E. frackowiak, F. Beguin. Applied Surface Science 228 (2004) 84-92.

[5]   M. Alshaaer, B. El-Eswed, I. Yousef, F. Khalili, H. Khoury, Low-cost Solid Geopolymeric Material for Water Purification, Ceramic Transactions Volume 207, page 265 -271, 2009.

[6]   R. Yousef, B. El-Eswed, M. Alshaaer, F. Khalili and H. Khoury, The influence of using Jordanian natural zeolite on the adsorption, physical, and mechanical properties of geopolymers products, Journal of Hazardous Materials, 165 (2009) 379-387.

[7]   R. Cioffi, L. Maffucci, L. Santoro " Optimization of geopolymer synthesis by calcination and polycondensation of kaolinitic residue" Resources, Conservation and Recyclic 40 (2003) 27-38.

[8]   G.M. Gemerts, R. Mishre and J. Wastiels, Stabilization of Kaolinitic Soils from Suriname for Construction Purposes, Vrije Universiteit Brussel, Brussels, Belgium, 1989.

[9]   H. Rahier, J. Wastiels, M. Biesemans, R. Willem, G. Van Assche, B. Van Mele, Reaction mechanism, kinetics and high temperature transformations of geopolymers, J. Mater. Sci. 42 (2007) 2982-2996

[10]   P. Duxon, A. Ferandez-Jimenez, J.L. Provis, G.C. Luckey, A. Palomo, J.S.J. van Deventer, Geopolymer technology: the current state of the art, Mater. Sci. 42 (2007) 2917-2933.

[11]   M. Alshaaer, Stabilization of kaolinitic soil from Jordan for construction purposes, M. Sc. thesis, Vrije Universiteit Brussel, Brussels, Belgium, 2000.

[12]   L. Li, S. Wang, Z. Zhu, Geopolymeric adsorbents from fly ash for dye removal from aquous solution, J. Colloid Interface Sci. 300 (2006) 52-59.

[13]   S. Wang, L. Li, Z.H. Zhu, Solid-state conversion of fly ash to effective adsorbents for Cu removal from wastewater, J. Hazrd. Mater. B 139 (2007) 254-259.

[14]   Bassam El- Eswed, Rushdi I. Yousef, Mazen Alshaaer, Fawwaz Khalili, Hani Khoury "Alkali solid-state conversion of kaolin and zeolite to effective adsorbents for removal of lead from aqueous solution" Desalination and Water Treatment, 8 (2009) 124–130.

[15]   T. W. Cheng, M. L. Lee, M.S. Ko, T.H. Ueng, S. F. Yeng. Applied Clay Science 56 (2012) 90-96.

[16]   Rushdi I. Yousef, Bassam El-Eswed,, Mazen Alshaaer, Fawwaz Khalili, Hubert Rahier. Degree of reactivity of two kaolinitic minerals in alkali solution using zeolitic tuff or silica sand filler Ceramics International, In Press, Corrected Proof, 2012.

[17]   Y. Ho "Pseudo-isotherms using a second order kinetic expression constant" Adsorption 10, 151-158, 2004.

[18]   Shaw, D. J. "Introduction to Colloid and Surface Chemistry". (chapter 5). Butterworth –Heinemann, Oxford (1992)

 
 
Top