Back
 ENG  Vol.5 No.1 B , January 2013
Advanced Burst Mode Control to Reduce the Standby Power of Flyback Converter
Abstract: This paper we proposed advanced burst mode control technique to reduce the standby power consumption of the switch mode power supply (SMPS). To reduce the standby power consumption, most of the converter use burst mode or skip mode control technique. However Conventional standby mode control techniques have some problems such as audible noise and poor regulation. In proposed techniques, basically, the burst mode control technique is employed to reduce the fundamental switching frequency while limiting the peak drain current. But, in proposed technique, to improve the regulation characteristic, burst period of the proposed technique is shorter than that of the conventional burst mode technique. And also, to reduce the switching loss increase due to the short burst period, burst switching signal of the proposed technique is partially skipped. By using proposed advanced burst mode control technique, calculated standby power is 0.695W while standby power of the conventional burst mode control is 1.014W.
Cite this paper: M. Kim, H. Kim, J. Jang and K. Kim, "Advanced Burst Mode Control to Reduce the Standby Power of Flyback Converter," Engineering, Vol. 5 No. 1, 2013, pp. 137-141. doi: 10.4236/eng.2013.51B025.
References

[1]   L. McGarry, “The standby power challenge” Proc. Of IEEE AGEC, pp. 56-62, 2004

[2]   Alan Meier, Wolf-gang Huber and Karen Rosen, “Reducing Leaking Elec-tricity to 1 Watt”, The 1998 ACEEE Summer Study on Energy in Buildings, August 1998.

[3]   J. P. Ross and Alan Meier, “Whole-House Measurements of Standby Power Consumption”, International Conference on Energy Efficiency in Appliances, September, 2000.

[4]   Hang-Seok Choi and D. Y. Huh, “Tech-niques to minimize Power Consumption of SMPS in Standby Mode”, Power Electronics Specialists Confe-rence2005, PESC, pp. 2817-2822, IEEE 36th, 2005.

[5]   Yoh Matsushita, “Design for low electric power during standby state of fax-copier machine”, In-ternational Symposium On Environmentally Conscious Design and Inverse Manufacturing, pp. 391-395. 1999.

[6]   A. I. Maswood, Z. K. Yoong, “Digital burst technique in the stand-by operation of a TV power supply”, IEEE IAS Annual Meeting, Industry Applica-tions Conference, pp. 1661-1668, 1999.

 
 
Top