Back
 JMMCE  Vol.8 No.7 , July 2009
Preparation of Al-5Ti Master Alloys for the In-Situ Processing of Al-TiC Metal Matrix Composites
Satish Babu Boppana*, K . Chennakeshavalu
Show more
Abstract: The present paper reports on the preparation of various Al-5Ti master alloys by the reaction of halide salt (K2TiF6) with molten Al in an induction furnace. The master alloys are supposed to be used for the in-situ processing of Al-TiC Metal Matrix Composites. During the preparation of these master alloys the reaction temperature was varied from 800-1000℃ with the intervals of 100℃, while the reaction time was varied at 45, 60 and 75 min. The binary master alloys prepared were characterized using image analyzer and particle size was measured. It was found that the master alloy Al-5Ti prepared at 8000C, and 45 minutes had a minimum particle size of 9.0 micrometer. Also it is observed that the population of particles less than 10 micrometer decreases at higher reaction temperature.
Keywords: Master-alloy, Al-TiC Metal Matrix Composites, Characterization
Cite this paper: S. Boppana and K. Chennakeshavalu, "Preparation of Al-5Ti Master Alloys for the In-Situ Processing of Al-TiC Metal Matrix Composites," Journal of Minerals and Materials Characterization and Engineering, Vol. 8 No. 7, 2009, pp. 563-568. doi: 10.4236/jmmce.2009.87049.
References

[1]   S.A.Kori, B.S.Murty, and Chakraborty:in “Preparation and Characterization of Al-B and BRich Al-Ti-B master alloys for the grain refinement of Al-7Si alloy”, AFS Trans,2001, 1-20.

[2]   B.S.Murty, S.A.Kori and M. Chakraborty: in ‘Grain refinement of Al and its alloys by heterogeneous nucleation and alloying, Inter. Mater. Reviews, 2002, Vol. 47, 1, 3-25.

[3]   L.F. Mondlofo, Al alloys- structure and properties, Butterworths, London, 1976, 228-229,385- 387,437-439.

[4]   C.S.Sivaramakrishnan, R.K.Mahanti, and R. Kumar: ‘Trans. Indian Inst. Met., 1976, 29, 452- 455.

[5]   S.Sivaramakrishnan and R. Kumar: Light Met. Age, 1987, 10, 30-34.

[6]   C.Q.Zhuxian, Y.Yaxin, Z. Mingjie, S. K. Grotheim, and H.Kvande: Aluminum, 1988, 64, 1254-1257.

[7]   K.Venkateswarlu, B.S.Murty, P.RamChandra Rao, and M. Chakraborty: Proc. Int. Seminar on ‘Non ferrous metals and materials’, Jan.2000, Jamshedpur, India, 193-198.

[8]   T.S.Krishnan, P.K.Rajagopalan.R.R Gund, J.Krishnan, and D.K.Bose: J.Alloy. Compd., 1998, 269, 138-140.

 
 
Top