Back
 EPE  Vol.4 No.4 , July 2012
Finite Element Analysis of Dynamic Damper for CV Joint
Abstract: Constant Velocity [CV] Joints are one of the most important components of front wheel drive axles. It is subjected to various stresses such as bending stress, shear stress and bearing stress. Apart from these stresses, it is also subjected to vibrations, due to out of balance tire or wheel and an out of round tire or wheel, or a bent rim. The main objective of this work is to reduce the stiffness of the damper, so that the damper can withstand within the required constraints [i.e. the forced frequency range of 80 Hz to 150 Hz]. The free vibrational and forced vibrational effects are investigated to predict the resonance phenomenon of the damper. Finite Element Analysis in ANSYS-11 software was performed to predict the dynamic behavior of the system under the required vibrational frequencies ranging from 80 Hz to 150 Hz at given loading conditions.
Cite this paper: R. Yerrawar, V. Tungikar and S. Gawande, "Finite Element Analysis of Dynamic Damper for CV Joint," Energy and Power Engineering, Vol. 4 No. 4, 2012, pp. 241-247. doi: 10.4236/epe.2012.44033.
References

[1]   E. Jack, “Automotive Technology: A System Approach,” 3rd Edition, Thomson Delmar Learning, Clifton Park, 1982, pp. 901-907.

[2]   S. Magirius and D. Booker, “High Speed Constant Velocity Joints, for Car and Light Truck Driveshaft,” SAE Paper 950891, 2005.

[3]   F. Greg and N. Y. Wani, “Finite Element Model Correlation of an Automobile Propshaft with Internal and External Damper,” SAE Paper 2004-01-0862, 2004.

[4]   S. Yu, “Development of Dual Mode Engine Crank Damper,” SAE Paper 2003-01-1675, 2003.

[5]   G. Flesch and O. Zambarda, “The Application of Experiments to a Constant Velocity Plunging Joint Manufacturing Process,” SAE Paper 2003-01-3524, 2003.

[6]   A. Albert and A. Howle, “Design Issues in the Use of Elastomers in Automotive Tuned Mass Dampers,” SAE Paper 2007-01-2198, 2007.

[7]   M. Tetsuji, “Influence of Dynamic Damper Pulley Design on Engine Front Noise,” SAE Paper 2001-01-1419, 2001.

 
 
Top