ACES  Vol.2 No.2 , April 2012
Numerical Study of Oil/Water Separation by Ceramic Membranes in the Presence of Turbulent Flow
Abstract: Disposal of produced water during petroleum extraction causes serious environmental damage, hence the need to complete the water treatment before being disposed to environment within the criteria set established by environmental agencies in the countries. Ceramics membranes have been highlighted as a good device for separating oil/water. These act as a barrier to oil in the aqueous stream, because their essential properties for filtration, such as chemical inertness, biological stability and resistance to high temperatures. The limitation of the separation process is the decay of permeate flux during operation, due to concentration polarization and fouling. In this sense, this paper aims to evaluate numerically the feasibility of the process of separating oil/water by means of ceramic membranes in the presence of a turbulent flow induced by a tangential inlet. The results of the velocity, pressure and volumetric fraction distributions for the simulations different by varying the mass flow rate inlet and different geometric characteristics of the membrane are presented and analyzed.
Cite this paper: Saraiva de Souza, J. , Mota Vieira, T. , Santos Barbosa, E. , de Lima Cunha, A. , Rodrigues de Farias Neto, S. and Gilson Barbosa de Lima, A. (2012) Numerical Study of Oil/Water Separation by Ceramic Membranes in the Presence of Turbulent Flow. Advances in Chemical Engineering and Science, 2, 257-265. doi: 10.4236/aces.2012.22030.

[1]   J. M. Neff, “Bioaccumulation in Marine Organisms: Effect of Contaminants from Oilwell Produced Water,” Elsevier, Netherlands, 2002.


[3]   OSPAR Commission, “Report on Discharges Spills and Emissions from Offshore Oil and Gas Installations,” 2005. Offshore%20report%202003.pdf

[4]   F.-R. Ahmadun, et al., “Review of Technologies for Oil and Gas Produced Water Treatment,” Journal of Hazardous Materials, Vol. 170, No. 2-3, 2009, pp. 530-551. doi:10.1016/j.jhazmat.2009.05.044

[5]   M. A. A. Zaini, R. G. Holdich and I. W. Cumming, “Crossflow Microfiltration of Oil in Water Emulsion via Tubular Filters: Evaluation by Mathematical Models on Droplet Deformation and Filtration,” Jurnal Teknologi, Vol. 53, 2010, pp. 19-28.

[6]   S. R. H. Abadi, M. R. Sebzari, M. Hemati, F. Rekabdar and T. Mohammadi, “Ceramic Membrane Performance in Microfiltration of Oily Wastewater,” Desalination, Vol. 265, No. 1-3, 2011, pp. 222-228. doi:10.1016/j.desal.2010.07.055

[7]   S. Benfer, U. Popp, H. Richter, C. Siewert and G. Tomandl, “Development and Characterization of Nano-filtration Membranes,” Separation and Purification Technology, Vol. 22-23, 2001, pp. 231-237. doi:10.1016/S1383-5866(00)00133-7

[8]   S. Ahmed, M. T. Seraji, J. Jahedi and M. A. Hashib, “CFD Simulation of Turbulence Promoters in a Tubular Membrane Channel,” Desalination, Vol. 276, No. 1-3, 2011, pp. 191-198. doi:10.1016/j.desal.2011.03.045

[9]   S. R. Lautenschlager, S. S. F. Filho and O. Pereira, “Mathematical Modeling and Operational Optimization of Ultrafiltration Membrane Processes,” Engenharia Sanitária Ambiental, Vol. 14, 2009, pp. 215-222. doi:10.1590/S1413-41522009000200009

[10]   D. F. Maia, “Development of Ceramic Membranes for Oil/Water Separation,” Ph.D. Thesis, Federal University of Campina Grande, Campina Grande, 2006.

[11]   R. Del. Colle, R. N. Haneda, E. Longo, M. J. Godinho and S. R. Fontes, “Method of Chemical Impregnation Applied to Microporous Tubes and Tubular Membranes for the Microfiltration of Emulsions and Suspensions of Bacteria,” Ceramica, Vol. 54, 2008, pp. 21-28.

[12]   ANSYS CFX, “User Manual Theory,” ANSYS CFX-Solver Theory Guide, ANSYS Inc., Canosburg, 2009.

[13]   A. L. Cunha, S. R. F. Neto and H. L. Lira, “Application of Fluid Dynamic Computational Oil/Water Separation in through Selective Membranes,” Proceedings of the 3th Congress of Scientific Initiation of the Federal University Campina Grande, Campina Grande, 2006, pp. 1-11.