Back
 EPE  Vol.4 No.2 , March 2012
Thermal Modeling of a Novel Heated Tip Injector for Otto Cycle Engines Powered by Ethanol
Alexandre Rezende, Jose Roberto Simoes-Moreira
Show more
Abstract: This work presents a thermal modeling of a new cold-start system technology designed for Otto cycle combustion based on the electromagnetic heating principle. Firstly, the paper presents a state-of-the-art review and presents the context of automobile industry where heated injectors are necessary. The novel method of electromagnetic heating principle to solve the cold-start problem is still in the development phase and it enables engine starting at low temperatures in vehicles powered by ethanol or flex-fuel vehicles (FFV). This new system technology should be available as an alternative to replace the existing system. Currently, the cold-start system uses an auxiliary gasoline tank, which brings some inconvenience for the user. Secondly, the aim was also to create a physical model that takes into consideration all the parameters involved on the heating process such as power heating and average heat transfer coefficient. The study is based on the lumped system theory to model the ethanol heating process. From the analysis, two ordinary differential equations arise, which allowed an analytical solution. Particularly, an ethanol heating curve inside the injector was obtained, an important parameter in the process. Comparison with experimental data from other authors is also provided. Finally, a sensitivity analysis of controlling parameters such as heating power and heat transfer coefficient variation. The paper is concluded with suggestions for further studies.
Keywords: Ethanol; Cold-Start System; Electromagnetic Heating; Heated Fuel Injector
Cite this paper: A. Rezende and J. Simoes-Moreira, "Thermal Modeling of a Novel Heated Tip Injector for Otto Cycle Engines Powered by Ethanol," Energy and Power Engineering, Vol. 4 No. 2, 2012, pp. 85-91. doi: 10.4236/epe.2012.42012.
References

[1]   M. S. Rocha and J. R. Sim?es-Moreira, “A Simple Impedance Method for Determining Ethanol and Regular Gasoline Mixtures Mass Contents,” Fuel, Vol. 84, No. 4, 2005, pp. 447-452. doi:10.1016/j.fuel.2004.09.011

[2]   Z. Fono, “An Empirical Study of the Heat Transfer of Three Inductively Heated Injector Concepts Using Alcohol Fuel E100,” Siemens VDO Automotive AG, 2007.

[3]   P. Hofmann and P. H. Lenz, “Ein schnell ansprechendes Flash-Boiling-Einspritzventil zur Verminderung der Emissionen im Kaltstart und Warmlauf,” Vortrag am 21, Internationales Wiener Motorensymposium, 2000.

[4]   A. Rezende, “Thermal Modeling of Heated Tip Injectors for Otto Cycle Engines,” Master Dissertation, Escola Politécnica da Universidade de S?o Paulo, S?o Paulo, 2009.

[5]   S. W. Churchill and H. H. S. Chu, “Correlating Equations for Laminar and Turbulent Free Convection from a Vertical Plate,” International Journal of Heat and Mass Transfer, Vol. 18, No. 11, 1975, pp. 1323-1329. doi:10.1016/0017-9310(75)90243-4

 
 
Top