OPJ  Vol.3 No.4 , August 2013
Opto-Electronic Investigation of Wet Coating Deposition of ITO Nanopowders on Flexible Substrate Using Pulse Nd-YAG Laser
ABSTRACT

Transparent thin layer indium tin oxide was coated on polyethylene tetraphetalate (PET) substrate by means of spin coating process and its opto-electronic properties have been investigated. The surface treated by pulse Nd-YAG laser. Pulse frequency, duration and energy were, 1000 Hz, 0.2 to 20 ms and 25 to 40 J respectively. The effect of treatment on crystallization, optical properties and bonding processes of the thin layer was investigated. The results show that ITO coated on flexible PET substrates is conductive and transparent. The sheet transparency for a 350 nm thickness in the visible range is more than 83.6%. Using Nd-YAG laser increased conductivity by a factor of 100 times and causes higher bonding performances.

Cite this paper
H. Salar-Amoli and H. Amani, "Opto-Electronic Investigation of Wet Coating Deposition of ITO Nanopowders on Flexible Substrate Using Pulse Nd-YAG Laser," Optics and Photonics Journal, Vol. 3 No. 4, 2013, pp. 300-303. doi: 10.4236/opj.2013.34046.
References
[1]   W. Zhu, G. Wang, X. Hong, X. Shen, D. Li and X. Xie, “Metal Nanoparticle Chains Embedded in TIO2 Nanotubes Prepared by One-Step Electrodeposition,” Electrochimica Acta, Vol. 55, No. 2, 2009, pp. 480-484. doi:10.1016/j.electacta.2009.08.059

[2]   B. ORegan and M. Gratzel,” A Low Cost High Efficiency Solar Cell Based on Dye Sensitized Colloidal TIO2 Films,” Nature, Vol. 353, No. 6346, 1991, pp. 737-740. doi:10.1038/353737a0

[3]   H. C. Lee and O. Oak-Park “The Evolution of the Structural Electrical and Optical Properties in Indium-Tin Oxide Thin Film on Glass Substrate by DC Reactive Magnetron Sputtering,” Vacuum, Vol. 80, 2006, pp. 880-887. doi:10.1016/j.vacuum.2005.11.069

[4]   S.-J. Hong and J.-I. Han “Indium Tin Oxide Thin Film Fabricated by Indium-Tin-Organic Sol including ITO Nanoparticle,” Current Applied Physics, Vol. 6, Suppl. 1, 2008, pp. 206-210. doi:10.1016/j.cap.2006.01.041

[5]   L. G. Li, G. H. Lu, X. N. Yang and E. L. Zhou, “Progress in Polymer Solar Cell,” Chinese Science Bulletin, Vol. 52, No. 2, 2007, pp. 145-158. doi:10.1007/s11434-007-0001-y

[6]   M. A. Green, “Thin-Film Solar Cells: Review of Materials, Technologies and Commercial Status,” Journal of Materials Science: Materials in Electronics, Vol. 18, No. 1, 2007, pp. S15-S19. doi:10.1007/s10854-007-9177-9

[7]   W. J. Lee, E. Ramasamy, D. Y. Lee and J. S. Song, “Glass Frit Overcoated Silver Grid Lines for Nanocrysyalline Dye Sensitized Solar Cells,” Journal of Photochemistry and Photobiology A: Chemistry, Vol. 183, No. 1-2, 2006, pp. 133-137. doi:10.1016/j.jphotochem.2006.03.006

[8]   S. I. Na, B. K. Yu, S. S. Kim, D. Vak, T. S. Kim, J. S. Yeo and D. Y. Kim, “Fully Spray-Coated ITO Free Organic Solar Cells for Low Cost Power Generation,” Solar Energy Materials & Solar Cells, Vol. 94, No. 8, 2010, pp. 1333-1337. doi:10.1016/j.solmat.2010.01.003

[9]   E. Shigeno, K. Shimizu, S. Seki, M. Ogawa, A. Shida, M. Ide and Y. Sawada, “Formation of Indium Tin Oxide Films by Dip Coating Process Using Indium Dipropionate Monohydroxide,” Thin Solid Films, Vol. 411, No. 1, 2002, pp. 56-59. doi:10.1016/S0040-6090(02)00187-6

[10]   G. H. A. Therese and P. V. kamath, “Electrochemical Synthesis of Metal Oxides and Hydroxides,” Chemistry of Materials, Vol. 12, No. 5, 2000, pp. 1195-1204. doi:10.1021/cm990447a

[11]   S. Zh. Karazhanov, “Temperature and Doping Level Dependence of Solar Cell Performance including Excitons,” Solar Energy Materials& Solar Cells, Vol. 63, No. 2, 2000, pp. 149-163. doi:10.1016/S0927-0248(99)00173-7

[12]   M. Hidalgo, F. Martin and J. J. Laserna, “Laser-Induced Breakdown Spectrometry of Titanium Dioxide Antireflection Coatings in Photovoltaic Cells,” Analytical Chemistry, Vol. 68, 1996, pp. 1095-1100. doi:10.1021/ac951002i

[13]   H. Salar Amoli and B. Fathi, “Effect of Pulse Nd-YAG Laser Beam Interaction on Annealing of Nanopowder ITO Using Spin-On-Glass” Journal of Sol-Gel Science and Technology, Vol. 59, No. 1, 2011, pp. 32-35. doi:10.1007/s10971-011-2457-0

[14]   H. Salar Amoli, S. Shokatian and M. Abdous, “Thermal Annealing Combination with Pulse Nd-YAG Laser Treatment of ITO on Polycarbonate Using Spin Coating Process,” Journal of Sol-Gel Science and Technology, Vol. 62, No. 3, 2012, pp. 319-323. doi:10.1007/s10971-012-2727-5

[15]   S. Maridha and D. Basak, “Effect of Thickness on the Structural, Electrical and Optical Properties of ZNO Films,” Materials Research Bulletin, Vol. 42, No. 5, 2007, pp. 875-882. doi:10.1016/j.materresbull.2006.08.019

[16]   W. J. Lee, E. Ramasamy and D. Y. Lee, “Effect of Electrode Geometry on the Photovoltaic Performance of Dye-Sensitized Solar Cells,” Solar Energy Materials & Solar Cells, Vol. 93, No. 8, 2009, pp. 1448-1451. doi:10.1016/j.solmat.2009.03.002

 
 
Top